lefebure ta-10 pm and overhaul tips

LeFebure TA-10 PM and Overhaul Tips BrainWaveTech All Rights Reserved 2010

LeFebure TA-10 PM & Overhaul TIPS Key #0915

1) The Kiosk door should never be lubricated and only cleaned with scotch bright pad.(The Teller terminal can be sprayed with Triflow at the base only)

2) The plunger Switch shaft and Brass Bearing Assembly are the major cause of service calls and should be removed and cleaned completely (or replaced) with a scotch brite pad and never lubricated. (Oil Impregnated Bearings See optional Torch Burn off Page 3)

3) The Pressure sensor should be replaced Yearly or at least every Year and a Half. (due to moisture dry climate's do better, Cannot be cleaned)

4) The Kiosk door switches, plunger switch and call and send switches should be replaced every three years.

5) The wires on the blower contractor should be moved every year to a new location. (there are 3)

6)7) The Teller door and Kiosk Door relays on the main logic board should be

swapped with the Mute and Delay relays every two years. (all relays the Same)


Tip: Auto Send BackShorting 11 and 17 on the Main 18 Pin Molex with simulate the Send button being pressed at the Teller terminal


OIL IMPREGNATED Bearings Burned out oil by Torch


Get Parts From GreenBrier 3046456263

Description

Lefebure Part Number

Seal (door top) Seal (door side, 2 required) Belt, drive (customer door) Switch w/lever (door open/close) Plunger switch (carrier arrival) Wear ring (for cust. door bottom) Blower motor [1] Valve assembly (on blower) Lock for key #0915 Key #0915 Clutch/pulley assy Receiver top (round collar) Cord (neoprene) Motor (door) Cap, AC 125V (Kiosk and Teller door motor) Pressure sensor kit (hose and switch) Swivel, 90° (pressure switch hose conn)

76-2447-3 76-2448-1 79-2522-5 69-3853-4 69-3854-2 76-2474-8 79-3313-A 76-4572-5 79-1719-6 56-2810-4 79-2593-8 76-9933-6 79-2540-1 79-2097-7 69-1700-4-AA 21-0092-1 79-3131-8


Tubing, 1/8-inch I.D. X 1-foot (for pressure. switch) Circuit board (does not include relays) Relay, 24VDC 5A Time delay circuity board Receiver bottom Circuit board assy., pre-amp (audio) Microphone Speaker Switch, Single-pole, double-throw (call/send) Call button Send button Transformer (120/24 VAC) Relay, 24VDC, 600VAC (Blower starter)

79-3129-7 62-0822-4AA 69-2864-3 62-0680-8 76-2470-5 64-1223-3 69-4506-4 69-4600-8 69-3701-3 75-5807-4 75-5808-2 69-6799-2 69-2913-6

Description

Lefebure Part Number

Housing, rotating (teller door) Wear tape, anti-friction (order by foot) Belt, drive (teller door) Switch assembly (five switches and caps) Pushbutton switch (on/off) Recall cap Pushbutton switch (Recall) Pushbutton switch (Tel open/cust unit open send) Send cap LED transmitter (CIK indicator on tell ctrl panel) Cord (neoprene sponge 4 Ft top of door) Switch, (plunger type - arrival) O ring (3.75-inch dia tube seal) Solenoid (vent valve) Valve body (two halves vent valve) Valve plate (vent valve) Switch with lever, (door open/close) Motor (door) Clutch/pulley assembly Capacitor, AC 125V, 216 - 260 MFD (door motor) Blower motor Gasket (for blower) Valve assembly (on blower) Seal (top of door) Seal, (side - nylon; 2 required) Pad, rebound

76-2320-0 79-3067-3 79-2346-5 76-2336-6 69-3849-7 76-0930-2 69-3774-2 69-3772-6 76-0932-9 69-2008-6 79-2450-1 69-3854-2 79-2172-6 79-2493-5 79-2537-2 79-2494-3 69-3853-4 79-2097-7 79-2593-8 69-1700-4-AA 79-3313 76-2216-0AM 76-4572-5 76-2349-7 76-2348-9 76-4711-4

lefebure ta-10 pm and overhaul tips

Documents