Slide 1

Slide 2 Slide 3 Lack of proper lubrication is the leading cause of premature wear or failure of rock drill components! Slide 4 Where is the football style lubricator used? How does the lubricator work? Where should the lubricator be installed? Personal Protective Equipment for drilling? What is the proper way to blow out the air line? How do you regulate the flow of lubricant? What is the proper way to fill the lubricator? Is the machine getting enough lubricant? Rock drill oil vs. rock drill grease? Slide 5 Rock drills. Air tuggers in manways or shaft stations. Pneumatic ventilation fans. Pneumatic cylinders for vent doors. Pneumatic cylinders for control gates. Small pneumatic hoists in shops. Slushers with pneumatic motors. Any pneumatic powered hand tools. Slide 6 Slide 7 The lubricator should be placed a maximum of 12 from the drill. Slide 8 WORKS BEST WHEN PLACED HORIZONTAL VERTICALVERTICAL NO Slide 9 Before proceeding with any drilling operation full personal protective equipment must be worn. This includes CSA approved: safety glasses, hard hat, gloves, double hearing protection (plugs/ muffs), steel toe boots. Slide 10 Slide 11 Slide 12 Slide 13 Slide 14 Oil produces a mist of oil in the air around the drill. Grease does not produce a mist in the air around the drill. Slide 15 Oil is washed out of the drill by excess water in the air. Grease is not washed out of the drill by water in the air. Slide 16 Oil remains liquid in all temperatures. Grease gets sticky in cold temperatures. Slide 17 Oil suspends in the air longer and reaches the drill faster. Grease drops out of the air quickly and takes longer to reach the drill. Slide 18 Drilling a drift round uses two full lubricators of oil. Drilling a drift round uses less than one full lubricator of grease. Slide 19 If using oil check the lubricant at the beginning of the shift and again halfway through the shift. If using grease check the level of the lubricant at beginning of each shift. Slide 20 Always blow the air hose before connecting. Pour some lubricant into the hose at the drill. Store drills in upright position out of water. Connect air & water hose together in storage. Stuff a rag in the chuck to keep dirt out. Check to be sure drill steel collars are clean. Use one lubricator for each drill. Check during operation for proper lubrication Always wear all CSA approved safety gear. Slide 21 Parts HeadQuarters Inc. C2-1175-Appleby Line Burlington, ON, Canada L7L 5H9 www.partshq.com Telephone: (905) 332-3271 Fax: (905) 332-9497 Toll free: (800) 267-2082 Slide 22 PHQ Inline football style lubricator Part No. 5048912 C$155.00 c/w hose & fittings 5048912HP C$255