kw - utica boilers kw series features a dependable cast iron heat ... at the same rate when heated....
TRANSCRIPT
FEATURES
The Utica Heating KW Series Boiler is an affordable oil-fired home heating solution.
Choice of Two Operating Controls – Honeywell or HydroLevel 3250
Oil-Fired Water BoilersKW
Quality Heat Exchanger Design –The KW Series features a dependable cast iron heat exchanger with cast iron push nipples. The sections and push nipples expand at the same rate when heated. By using similar materials instead of less expensive gaskets or steel push nipples, the boiler maintains a water tight seal.
Efficiency – The KW Series provides an annual fuel utilization efficiency of up to 86.1% as certified by the US Department of Energy.
Warranty – 20 Year Limited Heat Exchanger Warranty
Optional HydroLevel
Boiler Control with LWCO Protection
• Standard Honeywell control, with digital display anddiagnostics, monitors water temperature and delaysburner from starting until the residual heat energywith in the boiler is consumed.
• Optional HydroLevel 3250, with digital display anddiagnostics, adjusts the water temperature based onyour heating system demand which further reducesyour heating costs. It also features a built-in lowwater cut-off (LWCO) to protect the boiler frompotentially dangerous low water conditions.
2201 Dwyer Ave., Utica, NY 13501
Phone: (315) 797-1310
Fax: (866) 432-7329 PN 240009813 Rev. 1/17
USA Contractor Assistance:800-325-5479
Model Input RateNat. (MBH)(1)
HeatingCapacity
Nat. (MBH)(1)(2)
Net AHRI Rating Nat.(1) No.
ofSections
AFUE %(4)Water
(MBH)(1)(5)
Specifications: (All ratings and specifications subject to change)
Dimensions (Inches)
A B C 173/4
173/4
173/4
21
21
21
241/4
241/4
241/4
6
6
6
6
6
6
6
6
6
93/4
93/4
93/4
113/8
113/8
113/8
13
13
13
UH3KW0.60†
UH3KW0.75
UH3KW1.00†
UH4KW.90†
UH4KW1.25†
UH4KW1.50
UH5KW1.20†
UH5KW1.75
UH5KW2.00†
84
105
140
126
175
210
168
245
280
74
92
120
111
153
181
147
210
239
64
80
104
97
133
157
128
183
208
3
3
3
4
4
4
5
5
5
86.1
85.6
84.4
86.0
85.9
85.1
86.1
85.0
84.0
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x15'
8"x8"x20'
Minimum Chimney
Size/ Height
0.60
0.75
1.00
0.90
1.25
1.50
1.20
1.75
2.00
Input RateNat. (GPH)(3)
FRONT VIEW RIGHT SIDE VIEW BACK VIEW
9 "
OptionalTanklessCoilWater Heater with 1/2"
A BC
Water Outlet 1 1/4"
Limit Control
Low Limit Control(With Tankless Coil)
Relief Valve
Outlet
Oil Burner
Drain Valve(Furnished)
Temp/ Pressure Gauge
1 1/4" ReturnNipple &
Reducing Tee
19 1/2"
36 "
† These firing rates available only with alternate firing rate kits.
(1) Mbh = 1,000 BTU per hour[BTU = British Thermal Unit]
(2) Heating Capacity based on 13% CO2 with a0.02" w.c. draft over fire, and a #1 smoke orless. Testing was done in accordance with theD.O.E. (Department of Energy) test procedure.
(3) G.P.H. = Gallons per hour oil at 140,000 BTUper gallon
(4) A.F.U.E. = Annual Fuel Utilization Efficiencybased upon D.O.E. test procedure.
(5) Net AHRI Water Ratings based on piping andpickup allowance of 1.15. Consult manufacturerbefore selecting boiler for installations havingunusual piping and pickup requirements,such as intermittent system operation,extensive piping systems, etc.
Oil-Fired Water BoilersKW
STANDARD EQUIPMENT:
n
n
n
n
n
n
n
Assembled boiler with insulated jacket.Completely installed andwired Beckett AFG Series Oil Burner equipped with:
Oil NozzlePrimary ControlCAD CellPSC MotorInterrupted Duty Ignition and Clean Cut Pump
Flue BrushTarget Wall (Vacuum Formed Refractory Ceramic Fiber)DuraBlanket Insulation ChamberBarometric Draft Control 6"Combination Temperature/Pressure GaugeCirculator Pump wired with 5' harness for supply or return mounting in the field.3/4" Boiler Drain Valve30 psi ASME Relief ValveExtra Boiler Tap for Expansion Tank or Air Elmination
n
n
n
n
C.S.A Certified For Natural Gas or Propane
Tested for 100 psi. ASME Working Pressure