kg clamshell kg dragline - free crane specs5).pdf · calculated to comply with bs 1757-1986 clause...

MANITOWOC M-65W – 65-MTon liftcrane

6,804 KG CLAMSHELL 6,124 KG DRAGLINE

45

View thousands of Crane Specifications on FreeCraneSpecs.comView thousands of Crane Specifications on FreeCraneSpecs.com

MANITOWOC M-65W – Outline dimensions

46


MANITOWOC M-65W – Performance data

47


MANITOWOC M-65W – Shipping data (all dimensions length x width x height)

48


MANITOWOC M-65W – Liftcrane capacities boom no. 46

19 050 KG COUNTERWEIGHT 6 807 MM CRAWLERS EXTENDED 360° RATING

Capacities for various boom lengths and operatingradii are for freely suspended loads and arecalculated to comply with BS 1757-1986 clause 9,I.S.O. 4305 and BS 2573 part 1 – 1983 tables 5(a) and6(a). Capacities based on structural competence aredenoted by an asterisk(*).

Upper boom point capacity for liftcrane service withsingle part whip line is 6 800kg. In all cases, upperboom point capacities cannot exceed those listed forthe main boom capacity.

Weight of jib, all load blocks, hooks, weight ball,slings hoist lines, etc., beneath boom and jib pointsheaves, is considered part of the main boom load.Boom is not to be lowered beyond radii wherecombined weights are greater than rated capacity.Where no capacity is shown, operation is notintended or approved.

Machine to operate in a level position on a firmuniformly supporting surface with crawlers fullyextended (5 093mm) and gantry up. Refer to riggingno. 168744 and wire rope specification chart no.7536-A. Crane operator judgement must be used toallow for dynamic load effects of swinging,hoisting or lowering, travel, wind conditions, as wellas adverse operating conditions and physicalmachine depreciation.

Machine may be operated in winds up to thoseshown in table provided crane operator judgement isused to allow for wind effect on the lifted load andother considerations noted on the capacity chart arefollowed. Wind will have a considerable effect on aload with a large ‘sail area’ and must be compensatedfor accordingly by reducing load ratings, reducingoperating speeds or by a combination of both.Recommend stopping operation when wind is abovethose shown in table and tieing off or lowering boomwhen wind is above 16 m/s.

Machine to travel on a firm, level and uniformlysupporting surface and boom within the boom anglerange shown in capacity chart.

Operating radius is the horizontal distance from theaxis of rotation to the centre of vertical hoist lineor load block. Boom angle is the angle betweenhorizontal and centreline of boom butt and inserts,and is an indication of operating radius. In all cases,operating radius shall govern capacity. Boom pointelevation is vertical distance from ground level tocentreline of boom point shaft.

Machine equipped with 6 807mm extendiblecrawlers, 914mm treads, 5 182mm retractablegantry, 12 part boom hoist reeving, two 32mm boompendants, 1st counterweight = 15 875kg, and 2ndcounterweight = 3 175kg.

49




50




51




52


MANITOWOC M-65W – Liftcrane jib capacities(jib no. 130 with 3 658mm strut on boom no. 46)19 050 KG COUNTERWEIGHT 6 807 MM CRAWLERS EXTENDED 360° RATING

Chart supplements boom capacity chart no. 7534-AM. Capacities for various boom lengths, jib lengthsand jib operating radii are for freely suspended loadsand are calculated to comply with BS 1757-1986clause 9, I.S.O. 4305 and BS 2573 part 1 – 1983 tables5(a) and 6(a). Capacities based on structuralcompetence are denoted by an asterisk(*).

Weight of all load blocks, hooks, weight ball, slingshoist lines, etc., beneath boom and jib point sheaves, isconsidered part of the jib load. Boom and jib are notto be lowered beyond radii where combined weightsare greater than rated capacity.Where no capacity isshown, operation is not intended or approved.

Machine to operate in a level position on a firmuniformly supporting surface with crawlers fullyextended (5 093mm) and gantry up. Refer to boomrigging no. 168744, jib assembly no. 167951 and wirerope specification chart no. 7536-A. Crane operatorjudgement must be used to allow for dynamic loadeffects of swinging, hoisting or lowering, travel, windconditions, as well as adverse operating conditionsand physical machine depreciation.

Machine may be operated in winds up to thoseshown in table provided crane operator judgement isused to allow for wind effect on the lifted load and

other considerations noted on the capacity chart arefollowed. Wind will have a considerable effect on aload with a large ‘sail area’ and must be compensatedfor accordingly by reducing load ratings, reducingoperating speeds or by a combination of both.Recommend stopping operation when wind is abovethose shown in table and tieing off or lowering boomwhen wind is above 16 m/s.

Machine to travel on a firm, level and uniformlysupporting surface and boom within the boom anglerange shown in capacity chart.

Operating radius is the horizontal distance from theaxis of rotation to the centre of vertical hoist lineor load block. Boom angle is the angle betweenhorizontal and centreline of boom butt and inserts,and is an indication of operating radius. In all cases,operating radius shall govern capacity. Jib pointelevation is vertical distance from ground level tocentreline of jib point shaft.

Machine equipped with 6 807mm extendiblecrawlers, 914mm treads, 5 182mm retractablegantry, 12 part boom hoist reeving, two 32mmboom pendants, 1st counterweight = 15 875kg,and 2nd counterweight = 3 175kg.

Maximum capacity on 19mm British Dyform 6/8 1960 N/mm2 wire rope is 6 800kg.

53


MANITOWOC M-65W – Liftcrane jib capacities(jib no. 130 with 3 658mm strut on boom no. 46)

9.1m (30 FT) JIB19 050 KG COUNTERWEIGHT 6 807 MM CRAWLERS EXTENDED 360° RATING

54


9.1m (30 FT) JIB


55




56


12.2m (40 FT) JIB


57




58


12.2m (40 FT) JIB


59




60


15.2m (50 FT) JIB


61




62


18.3m (60 FT) JIB


63




64


18.3m (60 FT) JIB


65


kg clamshell kg dragline - free crane specs5).pdf · calculated to comply with bs 1757-1986 clause...

Documents