jpt131 pressure transmitterjetec electronics co., ltd. tel:04-23729418 fax:04-23724011...
TRANSCRIPT
JETEC ELECTRONICS CO., LTD. Tel:04-23729418 Fax:04-23724011 E-mail:[email protected]
2. The product cannot be used under below circumstances :
INSTRUCTION MANUALModel. JPT-131
1. The outdoor environment2. High electromagnetic interference environment3. Humidity over 90% RH or temperature above 65°C environment4. Water environment5. High corrosion or polluted environment
1. Caution : The product produced through strict testing process. It also meets the specification as shownon catalog. Under normal and correct using circumstance, the product has a warranty for one year.
1. Please maintain balance for the pressure in the tube and atmosphere pressure.2. If install in outdoor environment, the device should provide a protection for over pressure. 3. The power (V+) and output (OUT+) cannot be in wrong connection, it will lead to short circuit, and cause the damage to sensor output.
3. Installation :
4. Dimensions :Please follow the below instruction for installation:1. Set the product on pressure valve .2. First, lock the transmitter by hand and make sure it sealed.3. Open the pressure valve to balance the pressure inside.4. Use wrench to seal the pressure connection and pressure valve.
(1) (2) (3) (4)
(JPT-131) (*JPT-131LJ)
JETEC ELECTRONICS CO., LTD. Tel:04-23729418 Fax:04-23724011 Email: [email protected]
INSTRUCTION MANUALModel. JPT-131
Dimensions :HIGH TEMP.Normal TEMP.
27L 45
27
PT1/2"PT1/4"G1/2"G1/4"others on customer
27 30 45
27
4-20mA (2 wire)1-5V / 1-10V / 0-10V (3 wire) WIRING DIAGRAM :
1
23
Power Supply
Signal4
(IN +) (- GND)
(- GND)
1
23
Power Supply
OutSignal
4
(IN +)
Unit:mm
Dimensions :
WIRING DIAGRAM :
Unit:mm
2wire (4-20 mA) 3wire (1-5 / 0-5 / 0-10 VDC)
mA
Signal
Pressure Transmitter
24 VDC
White
Red+
RedWhiteBlack
V+Output+GND-
Pressure Transmitter
25±3 30±3 20
27
(JPT-131)
(JPT-131LJ)