Instruction manual

2

Thank you for your support in Onecut.

3

Asymmetrical moldingsInner corner - Left/Right

1. Fold out Onecut with the angle-plate to the left. Fold it out until it fits the corner.

2. Take Onecut away and flip it 180° to get it upside down.

3. Set the saw according to the angle-plate. You can press down the saw blade to insure the right angle.

4. Put the molding upside down on the opposite side of Onecut.

5. Hold the molding 45°between the saw table and the saw fence. Cut! Repeat the procedure starting with the angle-plate to the right.

4

Asymmetrical moldingsOuter corner - Left/Right

1. Fold out Onecut with the angle-plate to the left. Fold it in until it fits the corner.

2. Take Onecut away and flip it 180° to get it upside down.

3. Set the saw according to the angle-plate. You can press down the saw blade to insure the right angle.

4. Put the molding upside down on the same side as Onecut.

5. Hold the molding 45°between the saw table and the saw fence. Cut! Repeat the procedure starting with the angle-plate to the right.

5

Symmetrical moldingsInner corner - Left/Right

1. Fold out Onecut with the angle-plate to the left. Fold it out until it fits the corner.

2. Take Onecut away and flip it 180° to get it upside down.

3. Set the saw according to the angle-plate. You can press down the saw blade to insure the right angle.

4. Put the molding on theopposite side of Onecut.

5. Hold the molding 45°between the saw table and the saw fence. Cut! Repeat the procedure starting with the angle-plate to the right.

6

Symmetrical moldingsOuter corner - Left/Right

1. Fold out Onecut with the angle-plate to the left. Fold it in until it fits the corner.

2. Take Onecut away and flip it 180° to get it upside down.

3. Set the saw according to the angle-plate. You can press down the saw blade to insure the right angle.

4. Put the molding on the same side as Onecut.

5. Hold the molding 45°between the saw table and the saw fence. Cut! Repeat the procedure starting with the angle-plate to the right.

7

Rip cuttingInner corner/Outer corner - Left/Right

1. Set the saw blade accord-ing to the angle-plate.

1. Fold out Onecut with the angle-plate to left or right. Fold it in until it fits the corner.

3. Cut your material!

Examples of areas of use

Crown molding installations

Rip cutting

Window trimming

Door trimming

Base skirting

... and much more.

www.onecut.io