installation of artificial grass - eternal lawns · 2018-02-12 · bruntcliffe rd, morley, ls27 0lq...
TRANSCRIPT
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSADJACENT TO TIMBER BATON
EXISTING SUB BASE
HARDCORE 40MM
GRANITE ASH 20MM
ARTIFICIAL GRASS
65MM DECK SCREWSSOIL / BORDER
KILN DRIED SAND 5KG/M2
WEED SUPRESSING MEMBRANE
50MM2 STAKE SECUREDTO TIMBER BATONAT 1.2M CENTRES
75MM X 50MMTIMBER BATON
150MM ROUND WIRE NAILTO PERIMETER & JOINS AT300MM - 400MM CENTRES
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSFITTED OVER EXISTING DECKING.A 6MM UNDERLAY IS RECOMMENDEDFOR 25MM OR 30MM GRASSES. ARTIFICIAL GRASS,
40MM RECOMMENDED
TIMBER FRAME
DECKING BOARD
KILN DRIED SAND 5KG/M2
65MM DECK SCREWSTO PERIMETER AT
200-300MM CENTRES
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
[email protected] Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSADJACENT TO TIMBER SLEEPERS. FITTED FLUSH OR ABUTTED
GRANITE ASH 20MM
ARTIFICIAL GRASSKILN DRIED SAND 5KG/M2PATIO, DRIVE OR BORDER
TIMBERSLEEPERS
EXISTING SUB BASE
HARDCORE 40MMTIMBER SLEEPER
150MM ROUND WIRE NAILTO PERIMETER & JOINS AT300MM - 400MM CENTRES
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSADJACENT TO METAL EDGING - ALLOWS CURVED EDGES
ARTIFICIAL GRASS
KILN DRIED SAND 5KG/M2
WEED SUPRESSING MEMBRANE
SOIL, GRAVEL OR SLATE
EXISTING SUB BASE
HARDCORE 40MM
GRANITE ASH 20MM
150MM ROUND WIRE NAILTO PERIMETER & JOINS AT300MM - 400MM CENTRES
75MM OR 100MMMETAL EDGE
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSFITTED OVER TIMBER BATON
EXISTING SUB BASE
HARDCORE 40MM
GRANITE ASH 20MM
ARTIFICIAL GRASS
65MM DECK SCREWS
SOIL / BORDER
KILN DRIED SAND 5KG/M2
WEED SUPRESSING MEMBRANE
50MM2 STAKE SECURED TOTIMBER BATON AT 1.2M CENTRES
50MM X 50MMTIMBER BATON
65MM DECK SCREWSTO PERIMETER AT
200-300MM CENTRES
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
INSTALLATION OF ARTIFICIAL GRASSFITTED OVER EXISTING PAVING.
EXISTING PAVING
KILN DRIED SAND 5KG/M2
GRANITE ASH TO LEVELANY UNEVEN SUFACES
ADHESIVE TOPERIMETER
ARTIFICIAL GRASS
INSTALLATION OF ARTIFICIAL GRASSADJACENT TO PAVING OR HARD SURFACE
ARTIFICIAL GRASS
KILN DRIED SAND 5KG/M2
WEED SUPRESSING MEMBRANE
PAVING 50MM
SAND BED 20MM
HARDCORE 100MM
EXISTING SUB BASE
HARDCORE 40MM
GRANITE ASH 20MM
150MM ROUND WIRE NAILTO PERIMETER & JOINS AT300MM - 400MM CENTRES
Bruntcliffe Rd, Morley, LS27 0LQ 01133 200 801
ETERNAL LAWNS GUIDE TO JOINTING ARTIFICIAL GRASS
1.
PLACE THE FIRST PIECE OF GRASS IN POSITION AND ROLL OUT SECOND PIECE NEXT TO IT. POSITION GRASSES TO FIT WITH BEST JOINT POSSIBLE.
2.
NAIL DOWN EITHER SIDE OF THE JOINT APPROXIMATLEY 150MM TO 200MM AWAY FROM THE JOINT AND ABOUT 450MM APART. THIS WILL STOP THE GRASS FROM MOVING UNDER FOOT.
3.
USE A HAMMER TO DRIVE IN THE 150MM ROUND WIRE NAILS INTO THE GRASS AND SUB BASE. ENSURE NO GRASS GETS TRAPPED UNDER THE NAIL HEAD.
4.
PLACE JOINTING TAPE WHITE SIDE UP, GREEN SIDE DOWN, EQUALLY UNDER BOTH PIECES OF GRASS.
ETERNAL LAWNS GUIDE TO JOINTING ARTIFICIAL GRASS
5.
PULL BOTH PIECES OF GRASS UP FROM THE JOINT AND ENSURE JOINTING TAPE IS CLEAR OF DIRT.
6.
APPLY ARTIFICIAL GRASS JOINTING ADHESIVE GENEROUSLY AS SHOWN IN THE PICTURE. EACH 310ML TUBE WILL DO 4 LINEAR METERS.
7.
CAREFULLY SIT THE GRASS BACK IN PLACE, GOING ALONG THE JOINT TO ENSURE NO GRASS IS STUCK TO THE ARTIFICIAL GRASS ADHESIVE.
8.
APPLY KILN DRIED SAND, 5 KG PER METER SQUARED AND BRUSH THE GRASS UP.