© 2005 American Honda Motor Co., Inc - All Rights Reserved. BII 30230 (0507) 1 of 5

INSTALLATIONINSTRUCTIONS

Accessory Application Publications No.

Issue Date

JULY 2005

08U96-S6M-2001-91

2006 RSXCIGARETTE LIGHTERP/N 08U96-S6M-200

INSTALLATION

1. Make sure you have the anti-theft code for theradio, then write down the radio station presets.

2. Disconnect the negative cable from the battery.

Customer Information: The information in thisinstallation instruction is intended for use only byskilled technicians who have the proper tools,equipment, and training to correctly and safely addequipment to your vehicle. These procedures shouldnot be attempted by “do-it-yourselfers.”

PARTS LIST

Cigarette lighter harness

3 Wire ties

TOOLS REQUIRED

Flat-tip screwdriver

10 mm Combination wrench

Diagonal cutters

3. Turn the two knobs counterclockwise, andremove the driver’s dashboard lower cover bypulling it toward you (two retaining tabs and twohooks).

4. Turn the knob clockwise and remove the driver’sdashboard under cover from the holder by pullingit toward you (one clip).

BII 30230

Cigarette lighter

RETAININGTABS (2)

KNOB

DRIVER’SDASHBOARDLOWERCOVER

HOOKS (2)

HOLDER

DRIVER’SDASHBOARDUNDERCOVER

CLIP

KNOB

2 of 5 BII 30230 (0507) © 2005 American Honda Motor Co., Inc - All Rights Reserved.

CENTER LOWERCOVER

CLIPS (6)

RETAINING TAB

ACCESSORYSOCKET

VEHICLE 2-PINCONNECTOR

5. Pull the center lower cover toward you to releasethe one retaining tab and six clips.

9. Open the lid, and remove the accessory socketfrom the center lower cover by releasing the tworetaining tabs.

CENTER LOWERCOVER

RETAININGTAB

LID

ACCESSORYSOCKET

10. Remove the accessory socket protector from thecenter lower cover by releasing the two retainingtabs.

ACCESSORY SOCKETPROTECTOR

CENTER LOWERCOVER RETAINING

TABS (2)

6. Unplug the vehicle 2-pin connector from theaccessory socket, and remove the center lowercover.

7. Secure the 2-pin connector (black) of thecigarette lighter harness to the cigarette lighterharness with one wire tie.

WIRETIE

12-PINCONNECTOR

CIGARETTE LIGHTER HARNESS

2-PINCONNECTOR(black)GROUND

TERMINAL WIRE

GROUNDTERMINALWIRE

12-PINCONNECTOR WIRE TIE

8. Connect the 12-pin male and female connectorsof the cigarette harness, then secure those12-pin connectors and ground terminal wire to thecigarette lighter harness with one wire tie.

© 2005 American Honda Motor Co., Inc - All Rights Reserved. BII 30230 (0507) 3 of 5

12. Align the locating tab of the socket with the cutoutin the ring, and slide the socket of the cigarettelighter into the ring.

LOCATINGTAB

11. Slide the ring into the hole in the center lowercover in the direction shown.

RING

CENTER LOWER COVER

13. Remove the bolt that secures the fuse box, andlower the fuse box.

14. Unplug the vehicle 6-pin connector from the fusebox, and plug the 6-pin connector of the cigarettelighter harness there.

CIGARETTELIGHTERHARNESS6-PINCONNECTOR

15. On A/T vehicles, locate the 6-pin connector tapedto the cigarette lighter harness, and remove thedummy connector. Plug the vehicle 6-pinconnector you just unplugged from the fuse boxinto that connector.

FUSE BOX

DUMMYCONNECTOR(Discard.)

BOLT

6-PIN CONNECTOR

FUSEBOX

CIGARETTELIGHTERHARNESS

VEHICLE6-PIN CONNECTOR(A/T vehicles only)

CENTER LOWER COVER

RING CUTOUT

SOCKET

NOTE: On M/T vehicles, there is no 6-pinconnector plugged into the fuse box.

17. Reinstall the fuse box.

18. Route the cigarette lighter harness above thesteering shaft, then secure the cigarette lighterharness to the vehicle harness with one wire tie inthe area shown.

16. If the vehicle is equipped with optional fog lights,plug the fog light harness 6-pin connector into thecigarette lighter harness.

19. Route the 2-pin connector of the cigarette lighterharness to the center lower cover opening.

20. Connect the 2-pin connectors of the cigarettelighter harness and the vehicle harness to thecigarette lighter.

VEHICLEHARNESS

WIRE TIE

VEHICLEHARNESS2-PINCONNECTOR

21. Reinstall the center lower cover, and push thecigarette lighter into the socket.

22. Check that all wire harnesses are routed properlyand all connectors are plugged in.

24. Reconnect the negative cable to the battery.

25. Reset the clock and the radio station presets.

23. Reinstall all removed parts. Make sure that allretaining clips and tabs are securely fastened.

NOTE: Whenever the battery is disconnected, thedriver’s window AUTO function is disabled.

27. Start the engine. Push down on the driver’swindow switch until the window is fully open.

28. Pull up on the driver’s window switch to close thewindow completely, then hold the switch for2 seconds.

29. Test the window AUTO function.

FUSE BOX6-PIN CONNECTOR

FOG LIGHTHARNESS

CIGARETTELIGHTERHARNESS

STEERINGSHAFT

CIGARETTELIGHTER HARNESS

WIRE TIE

VEHICLEHARNESS

CIGARETTELIGHTER HARNESS

CIGARETTELIGHTERHARNESS

CENTER LOWERCOVER OPENING

CIGARETTELIGHTERHARNESS 2-PINCONNECTOR

CENTER LOWERCOVER

CIGARETTELIGHTERSOCKET

CIGARETTELIGHTER

4 of 5 BII 30230 (0507) © 2005 American Honda Motor Co., Inc - All Rights Reserved.

26. Test the operation of the cigarette lighter.

’

30. Do the ECM/PCM idle learn procedure.

• Make sure all electrical items are turned off.

• Start the engine. Hold the engine speed at3,000 rpm with no load (in Park or Neutral) untilthe radiator fan comes on.

• Let the engine idle for about 5 minutes with thethrottle fully closed and with all electrical itemsoff.

NOTE: If the radiator fan comes on during thisstep, the time when it is operating must not beincuded in the 5 minutes.

© 2005 American Honda Motor Co., Inc - All Rights Reserved. BII 30230 (0507) 5 of 5