insect control field days sponsored by the kansas fruit growers association

20
Insect Control Field Days Sponsored by the Kansas Fruit Growers Association

Upload: margery-barber

Post on 23-Dec-2015

214 views

Category:

Documents


0 download

TRANSCRIPT

Insect Control Field Days

Sponsored by the

Kansas Fruit Growers Association

Applications for Fruit Trees

Robert E. Wolf Extension Specialist Application

Technology

Biological and Agricultural Engineering

Calibration:• Placing the correct amount of product in the

desired location.– High volume by hand or with air– Low volume with air

• Amount of delivered air is important.– Displace 2X the tree volume – cfm

• Location of delivered air is important– Coverage uniformly throughout the tree– Minimize spray drift away from the orchard

• Knowing the travel speed is essential

Measuring Ground Speed

Speed(MPH)Distance(ft) x 60

Time(seconds) x 88

Where 1 MPH =

traveling 88 feet in 60 seconds

Ground Speed Measurement

Speed(MPH)Distance(ft) x 60

Time(seconds) x 88

Example: You drive along a 150-foot measured course and discover that 30 seconds are required to complete the course. Determine the MPH.

Speed = 150 x 60 = 9,000 = 3.4 MPH 30 x 88 2,640

Air Delivery Calculation:

Height x 3.14 x Diameter/2 cfm

Volume Tree 2

ft. 15 x 3.14 x ft./2 15 cfm

Volume Tree 2

2650 cfm per tree

Required Air Capacity:

spacing tree

per tree cfm x sides of # x (MPH) travelof rate

cfm

CapacityAir Required

ft. 20

per tree cfm 2650 x 2 x (MPH) 1

cfm

CapacityAir Required

23,320 cfm

1 mph = 88 ft. per sec.

Application Rates:• Product per 100 gallons of water

– Based on standard trees– Point of run-off (dilute)– @ 400 gal/acre

• Product per acre– Based on modern air carrier sprayers– Speed sprayers– More efficient– Point of run-off not necessary– Low volume (40 – 80 gal/acre)– Also referred to as concentrate spraying

Dilute Spraying:

• Dilute volume = the amount of spray liquid to cover one acre of trees to point of run-off.

• Determined by experience or using a formula

• Tree-row volume method for smaller trees– Determine dilute volume– Determine the concentrate rate of

pesticide/acre

Tree-Row Volume: (Dilute)

• Based on tree size and spacing

• Table (Ohio State Extension Bulletin 892)– Rule of thumb based on tree density– 0.7 to 1.0 gal/1000 cu. ft.

• Row length per acre = 43,560 sq. ft. in an acre divided by the distance between rows in feet.

Determining Tree-row Volume

Tree-row volume =

(canopy width) x (tree height) x (row length per acre)

ft 18

ft./acre sq. 43,560 x ft. 8 ft. 10

ft./acre cu. volumerow-Tree x

rowsbetween distance

ft./acre sq. 43,560 x height(ft) Tree t)diameter(fcanopy Tree

ft./acre cu. volumerow-Tree x

ft. cu. 193,600 ft. 2,420 ft. sq. 80 ft./acre cu.

volumerow-Tree x

Determining Amount of Water-Dilute

Minimum/Maximum dilute volume (GPA) =

(tree-row volume (cu. ft./acre) x min/max gal/cu. Ft.

ft. cu. 1,000

gal. 0.7 x

/acreft. cu.

volumerow-tree

gpa volumedilute minimum

ft. cu. 1,000

gal. 0.7 x

/acreft. cu.

193,000

gpa volumedilute minimum

acreper gallons 136 gpa

volumedilute minimum

Determining Amount of Water-Dilute

Minimum/Maximum dilute volume (GPA) =

(tree-row volume (cu. ft./acre) x min/max gal/cu. Ft.

ft. cu. 1,000

gal. 1.0 x

/acreft. cu.

volumerow-tree

gpa volumedilute maximum

ft. cu. 1,000

gal. 1.0 x

/acreft. cu.

193,000

gpa volumedilute maximum

acreper gallons 194 gpa

volumedilute maximum

Determining Amount of Pesticide for Dilute Applications

volumedilute x rate dilute reproduct/ac ofAmount

acre

waterof gallons x

gallons 100

pesticide of amt. reproduct/ac ofAmount

lbs./acre 3.0 acre

waterof gal. 400 x

gallons 100

pounds 0.75 reProduct/ac

lbs./acre 0.9 acre

waterof gal. 120 x

gallons 100

pounds 0.75 reProduct/ac

Concentrate Spraying:

• As water amount decreases the pesticide amount increases proportionately – BUT NOT BY ADDING MORE PESTICIDE TO THE TANK!!!

• Example:– 1/3 less water means 3X pesticide

volumeeconcentrat

volumedilute ion Concentrat

3 gallons 80

gallons 240 ion Concentrat

Determining the Amount of Pesticide for Concentrate Applications

acre

waterof volumedilute standard x

waterof gal. 100

pesticide ofamount acrepesticide/ of rate Full

acre

lbs. 6.0

acre

waterof gal. 400 x

gallons 100

pounds 1.5

acre

rate full

Calculations for Concentrate Applications:

• Using the per acre rate level– No calculations needed– Take rate directly from the label

• Example (Assail 70WP)• Pome Fruits: 1.0 – 3.4 ounces per acre• Apply in at least 80 gallons per acre

– Acres based on the tree spacing

rowsbetween distance

ft./acre sq. 43,560 elength/acr row

ft. 2,420 ft 18

ft./acre sq. 43,560

Selecting Nozzle Size:

Based on gallons/acre = sprayer discharge rate

495

ft. width row x MPHGPA x GPM

14.84 495

ft. 18 x 3 x 136 GPM

14.84/2 = 7.42 gpm / side / 7 nozzles = 1.06

Selecting Correct Orifice:

• Chart – TeeJet (hollow cone tips)– Select a pressure along top (80 psi)– Move down column to locate 1.07 gpm– Move left to 1st and 2nd column

• D10 disc with a DC25 core/whirl plate

– Select 60 psi– Follow same routine

• D8 disc with a DC45 core/whirl plate

For more information contact:

www.bae.ksu.edu/rewolf/

[email protected]