INSTALLATION GUIDE

INLINE INSTALLATION / DEPLOYMENT

Version 01 Dated 09-10-2013 INTECSEA ICT TEAM (Oliver REBELLO)

Outline: This document outlines the current procedure to follow in regards to deploying the INTECSEA Inline

Tectools software on a users machine.

Summary instructions: The installation of Inline is a two-step procedure. The first installation of Inline on any machine needs

to be from an Admin account Preferably an IT account. During that phase, Inline will install any pre-

requisites required for the software. Once that is completed, any users wanting to run Inline from that

machine needs to run the setup file at least once from their profile to initialize the Inline office

component on their profile The user profile initialization doesnt require admin rights and any user can

do it pending step one was completed.

Step By Step Instructions: (Step 1 of 2) 1. From An Admin account (preferably IT) run the Setup.exe file

2. The following window should appear Select Accept

3. Select Install on the last Wizard.

INSTALLATION GUIDE

INLINE INSTALLATION / DEPLOYMENT

Version 01 Dated 09-10-2013 INTECSEA ICT TEAM (Oliver REBELLO)

Once completed, you should see the below window.

4. Select Close

5. Copy the Inline excel spreadsheet to the desktop and open. If successful you should see the

following with no any other error messages

Running from users profile First Time: (Step 2 of 2) This section assumes that Inline has already been installed once on the machine from an account with

admin rights as per the Step by Step Instructions listed above.

1. From the users profile, run the Setup.exe file

2. Select Install Close

3. Copy the Inline excel spreadsheet to the desktop and open.

NOTE TO ALL USERS:

To run the Inline Spreadsheet from the Network please refer to section 3 of the INLINE

Manual (229404-SU-MAN-0001).

INSTALLATION GUIDE

INLINE INSTALLATION / DEPLOYMENT

Version 01 Dated 09-10-2013 INTECSEA ICT TEAM (Oliver REBELLO)

Troubleshooting: Listed below are a few error messages/ cases that may occur if steps 1 and 2 are not followed or general

known issues.

CASE 1 If you get the following message when opening the Inline spreadsheet

Reason/Solution: Step 2 of 2 was not followed. The Initialisation process did not happen on the

users profile. To fix, run Step 2 Running from the users profile First Time: (Step 2 of 2).

CASE 2: Running the Inline spreadsheet from a network location may generate the following error message

Reason/Solution: Please refer to section 3 of the INLINE Manual (229404-SU-MAN-0001).