HVAC

Wiring diagram 5 channel output (5A relay)

Speed: High/Medium/Low

Mode: Cooling / Heating /Dehumidifier

HVAC is a module specially for Air Conditioner controlling. Coordinate with DLP, it can can completely and smartly run an Air Conditioner.

LN

485总线

switch 1,2,3

Basic information

HVAC

Device subnet ID and Device ID

Remark

Modify subnet ID and Device ID

HVACSettings

Delay time setting

1-10V Fan speed control voltage setting

HVACSettings

Function: Cool / Heat / Dehumidifier / Disable

Sequence running :1.Run Step1 15 minutes ON

2.R un step2 2 minutes OFF

3.R un step3 8 minutes ON

4.R un step4 2 minutes OFF

5.Run Step1 15 minutes ON

6.…..

HVAC

AC running test: select AC mode and FAN speed, click ‘Test’ , The HVAC module will run as settings.

Settings

HVAC DLP has a special page for AC module controlling, so we need a setting before using.

Enter HVAC’s subnet ID and Device ID

Programming on DLP

DLP has a temperature sensor, if enabled, DLP will broadcast detected current temperature to a specific device or to all devices( act as a input condition for logic controlling ).

Enable the DLP’s AC function

Programming on DLP

1.Click to setup

2. Select to show/hide functions on DLP’s LCD

Functions show/hide setting

HVAC

Select Fan speed and mode