hp 3g swap(1)
TRANSCRIPT
-
7/27/2019 HP 3G SWAP(1)
1/9
BSNL PHASE 3G-Cluster SWAP Pre & Post TEST REPORT
No of NodeBCircle
SSA:
Cluster/Town:
Date of Issue:
XXXX CIRCLE
-
7/27/2019 HP 3G SWAP(1)
2/9
1.SWAP Acceptance Test Procedure
Cluster AT should including Drive test and OMC monitoring.
2. Coverage AT test results will include following:
1. RSCP Plot
2. Ec /Io Plot
3. Best Server Plot
4. Handover status Plot
5. Throughput Plot
6. Eb/No Plot
3. SWAP Node B information.
SSA SDCA City/Town Cluster RNCID Site ID Site Name Lat Long 3G/2G/dual
4. DT Tools and Cluster/Route Planning4.1 Drive Test Tool
The Drive Test will be done with NEMO/TEMS with Calibrated Mobiles.
Device Type of call Mode comment
Setup MS1 Voice short Call UMTS 30 sec duration & 10 sec gap
MS2 Voice Long Call UMTS Continuous
MS3 HSDPA_Long UMTS Dedicated mode
MS 4 Voice UMTS/GSM Continuous
-
7/27/2019 HP 3G SWAP(1)
3/9
4.2 DT Drive Route and Cluster DistributionCluster & Drive test Route will be mutually agreed and Finalized by BSNL and ZTE.
5. Drive Test Process
5.1 Drive Test Statistics (Pre-Post Comparison)
5.1.1 CS Voice Call AMR 12.2kbps
Call Setup Success Rate
Cluster/Town NameCall attempts Call success Call Success Rate (%)
Pre Post Pre Post Pre Post
Handover Success Rate (IRAT)
Cluster/Town NameHandover attempts Handover success Handover Success Rate (%)
Pre Post Pre Post Pre Post
5.1.2 PS and HSPA
PS Call Success Rate
Cluster/Town NamePS Call attempts PS Call success PS Call Success Rate (%)
Pre Post Pre Post Pre Post
-
7/27/2019 HP 3G SWAP(1)
4/9
PS Call Drop Rate
Cluster/Town NamePS Call attempts PS Call Drop PS Call Drop Rate (%)
Pre Post Pre Post Pre Post
5.2 Drive test plots and Statistics (Pre-Post Comparison)
5.2.1 RSCP Plot
Coverage plot indicating the Received Signal Code Power [RSCP] in intervals of 6db commencing
from -75dbm.
Pre:
Post:
-
7/27/2019 HP 3G SWAP(1)
5/9
5.2.2 Ec/Io Plot
Pre:
Post:
Range Count Cumulation(%) Density(%)Pre Post Pre Post Pre Post
[-75,0]
[-85,-75]
[-95,-85]
[-105,-95]
[-115,-105]
-
7/27/2019 HP 3G SWAP(1)
6/9
5.2.3 HSDPA Throughput PlotPre:
Post:
Range samples Count % of samples
Pre Post Pre Post
[-6,0]
[-12,-6)
[-18,-12)[
-
7/27/2019 HP 3G SWAP(1)
7/9
6.CQIValues and the Modulation Type for UE in HSDPA PS Call Mode
The measured CQI values for HSDPA shall be submitted along with the HSDPA Category of
the UE used for the measurement and also with the Modulation type used at the instant. The
following format may be followed along with the location information. The below mentioned
data shall be provided in MapInfo Compatible TAB format also.
CQI Modulation Type UE HSDPA Category Throughput
Range samples Count % of samples
Pre Post Pre Post
[0,384)
[384,512)[512,1024)
[1024,5120)
[5120,10240)
[10240,14400)
Total
-
7/27/2019 HP 3G SWAP(1)
8/9
CQI Modulation Type UE HSDPA Category Throughput
6.1 Pilot Pollution Analysis
The pilot pollution information for every cluster shall have the following break ups:
i. At any given area, the total number of pilots available (in active, monitored or detected
set) with Ec/Io value above a threshold (-12dB) is 4 or more.
ii. At any given area, the total number of pilots available (in active, monitored or detected
set) within 5dB range of the Ec/Io value of best server, are 4 or more.
iii. Occurrence of both of the above conditions.
6.1.2 WCDMA Drive Test Tool READING
S.No. Name of
Location
Scrambling
Code
Cell id Measured
RSCP
Measured
Ec/lo
7. OMC KPI Comparison Report
Pre-Post KPI:
KPI Pre PostRRC Establishment Success Rate
RAB Establishment Success Rate, Voice
RAB Establishment Success Rate, PS
RAB Establishment Success Rate, HSDPA
RAB Establishment Success Rate, HSUPA
Call Drop Rate, CS AMR12.2k
Call Drop Rate, PS
HSDPA Call-Drop Rate
HSUPA Call-Drop Rate
IRAT Handover Success Rate (WCDMA->GSM)
-
7/27/2019 HP 3G SWAP(1)
9/9
The report confirms that ZTE has passed these SWAP sites Acceptance Test
Approved by
_______________________ ___________________________
ZTE Representative BSNL Representative