how to make leather wrapped fringe earrings · cut 2’ of 26 gauge wire-copper and wrap the folded...
TRANSCRIPT
www.nunndesign.com 1Copyright © 2016 by Nunn Design LLC, all rights reserved. 1-800-761-3557
SUPPLIES NEEDED FROM KIT: 38” Deerskin Lace Leather 5mm-Chocolate (dsl5c-b)4’ 26 Gauge Wire-Copper2 9mm Textured Jump Ring Circle-Copper (jr9tc-cb)2 Grande Rope Jump Ring-Copper2 Ear Wires-Copper12 4mm Pearl Beads
TOOLS NEEDED:1 pair of Flush Cutters2 pair of Needle Nose Pliers1 Ruler1 Pair of Scissors
How to Make Leather Wrapped Fringe EarringsDesigner: Becky Nunn
1.
4.
7.
2.
5.
8.
3.
6.
9.
STEP 1: (Images 1-2)Cut the Deerskin Lace Leather 5mm Chocolate into 3 separate 6” lengths. Thread the Deerskin Lace Leather through the Grande Rope Jump Ring and fold at the center.
STEP 2: (Image 3)Cut 2’ of 26 Gauge Wire-Copper and wrap the folded over Deerskin Lace Leather several times, securing the leather to the Grande Rope Jump Ring.
STEP 3: (Images 4-6)Thread and wrap each of the six 4mm pearl beads onto the Deerskin Lace Leather. When the pearls are wrapped in a cluster, tuck the end of the wire into the wrapped area and trim. You should have excess wire that you will need to use in Step 4. Once the tassel is assembled, trim the ends of the Deerskin Lace Leather to the desired length.
STEP 4: (Images 7-8)Cut 1” of Deerskin Lace Leather. Make an oval loop with one end overlapping the other. Make sure there will be plenty of room on both ends of the loop to thread through the Grande Rope Jump Ring and the 9mm Textured Jump Ring. Wire wrap 1” of 26 Gauge Copper Wire in the center of the loop.
STEP 5: (Image 9)Attach both jump rings to the oval loop created in Step 4. Attach the Ear wire to the top of the 9mm Jump Ring.
STEP 6:Repeat Steps 1-5 to make your matching set!