how to detect and clean a faulty mass airflow sensor
DESCRIPTION
Hey if you are looking for Mass Air Flow Sensor parts with 2 Years Warranty & Free Shipping with comparatively lowest pricing available then Shop today at www.theautopartsshop.comTRANSCRIPT
How to Detect and Clean a Faulty Mass Airflow Sensor
Basically a Mass airflow sensor (MAS) monitors the mass of air entering a vehicle’s
fuel injection engine, and passes that data to the Engine Control Unit as oxygen & fuel are the necessary elements to create combustion. Combining the right amount of fuel with the
right amount of oxygen is essential in maintaining maximum engine performance.
The air mass information is necessary for the ECU to correctly balance and deliver the
correct amount of fuel to the engine. Your car engine features either a vane meter or hot
wire sensor. There are two types of different mechanisms used to measure airflow entering the
engine. A vane meter utilizes a spring-loaded arm while the hot wire uses a heated wire. Both
use temperature and air volume to calculate air mass.
When a vehicle’s mass airflow sensor is faulty or defective it can cause a variety of
problems, and usually results in very poor performance from your engine. Car engine
could be very hard to make a start or make a turn over or could stall shortly after starting. There
could be symptoms of jerking during acceleration or could drag under load or when left in idle
mode.
Here are few guide lines which you can do it yourself at your home garage :
To clean Mass Air Flow sensor, you will have to take it out and for that you will have to
open your vehicle’s Air box. While removing the Sensor there could be few wires
attached which are delicate and small be cautious while unplugging them & do remember
their individual circuit slots for later rewiring purpose.
There are two options. The cheapest option would be to take your Mass Airflow Sensor
and place it in a plastic bag filled with rubbing alcohol. You will have to shake the bag
and move it around, making sure the alcohol washes all of the dirt and grime from the
Sensor. Another option would be to go to your local auto parts store and buy a special
Mass Airflow Sensor cleaner, and spray it onto your vehicles Sensor to clean all dirt from
it.
After cleaning your Mass Airflow Sensor with either the cleaner, or rubbing alcohol, let it
generally sit around for about 20 minutes or more. The Sensor has to be completely dry
before it can be reinstalled in your car, otherwise you may damage it. Replace the cleaned
Sensor in the engines Air box and plug the wires in their individual slots.
Cleaning your cars Mass Air Flow Sensor every six months or whenever you change your
vehicles engine oil would be a good idea as you could save your valuable time and
money.
You need to know the various symptoms of a bad Mass Air Flow Sensor, to diagnose the
problem accurately.
Troubleshooting of Mass Air Flow system is usually beyond the abilities of a
do-it-yourself er because it often requires specialized training and tools & could
mess up your hands. In case, you are not confident about pulling off this
procedure, take the help from a Car mechanic. Staying alerted from any of the warning signs mentioned above, you will have a much
better chance of finding and fixing these kind of engine problems before it becomes
costly and dangerous issue to tackle.
Hey if you are looking for Mass Air Flow Sensor parts with 2 Years Warranty & Free
Shipping with comparatively lowest pricing available then Shop today at
www.theautopartsshop.com
See more at: http://blog.theautopartsshop.com/how-to-detect-and-clean-a-faulty-mass-airflow-
sensor/