honda cbr1100xx s u p p l e m e n t a r y m a n u a l...honda cbr1100xx 2001-2008 remove the seat. s...

3
Honda CBR1100XX 2001-2008 Remove the seat. www.healtech-electronics.com S U P P L E M E N T A R Y M A N U A L for QSE-1 + QSH-P2T PAGE 1/3 Lift up or remove the fuel tank. Take off the Black/White terminal from one coil. Connect the QSH Green terminal to this coil terminal.

Upload: others

Post on 27-Jan-2021

1 views

Category:

Documents


0 download

TRANSCRIPT

  • Honda CBR1100XX2001-2008

    Remove the seat.

    www.healtech-electronics.com

    S U P P L E M E N T A R Y M A N U A Lfor QSE-1 + QSH-P2T

    PAGE 1/3

    Lift up or removethe fuel tank.

    Take off the Black/White terminal from one coil.

    Connect the QSH Green terminal to this coil terminal.

  • Honda CBR1100XX2001-2008

    www.healtech-electronics.com PAGE 2/3

    Take off the Black/White terminal from the 2nd coil.

    Connect the QSH Green terminal to this coil terminal.

    Isolate the unused Black/White terminal with tape.

    Splice the QSH White wire to the Yellow/Blue or Blue/Yellow

    wire of the coil by using the supplied red wire tap

    connector.(refer to the QSH-P2T instructions)

    Connect the Black/White terminal to the QSH Red wire

    terminal and secure with tape.

  • Honda CBR1100XX2001-2008

    www.healtech-electronics.com PAGE 3/3

    Typical position for theQuickShifter easy.

    Connect QSH black wire terminal to chassis ground.

    Mount the QSE Sensor.(Replace the bolt with the one supplied.

    Place the conical washers at the two sides ofthe sensor like this: (0). Tighten the bolt in

    this position by about 5 Nm. If you do not havea torque wrench, tighten the bolt until the

    shift arm is tight on the gearbox shaft.For different mounting options,

    refer to the sensor install guide.)