REINFORCED WOOD SURFACEQ-Plank featuring Woodura® has a reinforced wood surface created by fusing a thin sheet of wood onto a wood fiber core through a powder mix layer. The powder mix perfectly fills up the natural openings of

the wood, enhances the wood appearance and creates a significantly stronger surface with a hardness about three times greater than a traditional solid oak layer.

www.wikinggulve.dk

The Woodura® word mark and logos are registered trademarks owned by Välinge Innovation AB and any use of such marks are under license.

Hardened WoodFlooring

4. DISMANTLING

3. FLOOR INSTALLATION

2. SUBFLOOR PREPARATIONS

1. INSTALLATION PREPARATIONS

IMPORTANT INFORMATION

• Packages must be acclimated a minimum of 24 to 48 hours prior to installation in the room where the installation will take place.• In rooms larger than 15 x 15 m (225 m2), the flooring must be installed in smaller sections with expansion joints.• The distance to walls and other permanent pieces of construction elements (such as pillars and kitchen islands)

should be approximately 1,5 mm per meter of the length and width of the floor (width 10 m = 15 mm expansion gap).• Never install very heavy pieces of furniture such as kitchen islands/cabinets on top of the flooring.• The indoor climate should have a temperature between 15-23°C and relative air humidity between 30-60%

(according to Swedish Standards Institute).• Always follow the floor manufacturers requirements and specifications regarding subfloor preparation. For more detailed floor installation instructions, please visit: www.wikinggulve.dk

www.wikinggulve.dk

5. CLEANING & MAINTENANCE

200 mm

5 mmunderlay material:

CC ≥ 20 kPaCS ≥ 60 kPa

Thickness ≈ 2 mm

15-27 °C

≥ 15-23 °C

< 5 min

Type W“soft”

d ≤ 90% RHat 20 °C

30-60%at ≈ 20 °C

d ≤ 90% RHat 20 °C

48 h(72 h)

PE-foil over floor heating

CT: < 2 CM%CA/CAF: < 0.5 CM%

CT: < 1.8 CM%CA/CAF: < 0.3 CM%

≥ 400 mm≥ 400 mm