fsk modulation ppt
TRANSCRIPT
FSK MODULATION AND
DEMODULATION
PRESENTED BY ARUN KUMAR .M
BALA VINAYAGAM.KELANTAMILAN
What is modulation?
Modulation is the varying one or more properties of a high-frequency periodic waveform, called the carrier signal, with a modulating signal which typically contains information to be transmitted.
What is demodulation?
Demodulation is the process of eliminating the Carrier signal and recovering the base band message signal from the modulated signal is termed as Demodulation.
In ANALOG modulation, the modulation is applied continuously in response to the analog information signal.
In DIGITAL MODULATION, an analog carrier signal is modulated by a discrete signal.
TYPES OF MODULATION
.
IC555 TIMER
The LM555 is a highly stable device for generating accurate time delays or oscillation.
In the time delay mode of operation, the time is controlled by one external resistor and capacitor.
The circuit may be triggered and reset on falling waveforms, and the output circuit can source or sink up to 200mA or drive TTL circuits.
For astable operation as an oscillator, the free running frequency and duty cycle are controlled with two external resistors and one capacitor.
INTERNAL BLOCK DIAGRAM OF IC555
FEATURES OF IC555 Timing from microseconds
through hours. Operates in both astable and
monostable modes. Adjustable duty cycle. Output can source or sink 200
mA. Output and supply TTL
compatible. Temperature stability better
than 0.005% per ˚C. Normally on and normally off
output Available in 8-pin MSOP
package.
Precision timing Pulse generation Sequential timing Time delay generation Pulse width modulation Pulse position modulation Linear ramp generator
APPLICATIONS OF IC555
FSK MODULATION
FSK is a frequency modulation scheme in which digital information is transmitted through discrete frequency changes of a carrier wave Frequency Shift Keying Modulated signal is obtained using IC 555 TimerThe standard digital data input frequency is usually 150HzWhen the input is HIGH i.e.when the input binary data is of logic 1, the PNP transistor Q is off and IC 555 Timer works in the normal astable mode of operation.
FSK MODULATION AND DEMODULATION USING IC555
Digital information is transmitted through discrete frequency changes of a carrier wave.
With BFSK scheme, the "1" is called the mark frequency and the "0" is called the space frequency.
The time domain of an FSK modulated carrier is illustrated in the figures to the right.
GENERATION OF FSK
SOFTWARE IMPLEMENTATION OF THE CIRCUIT
FSK DEMODULATIONthe process of demodulation is achieved using Phase Locked Loop (PLL) IC 565. The demodulator receives a signal
at one of the two distinct carrier frequencies 1,270 Hz or 1,070 Hz.
The comparator prevents the amplitude changes occurring at the output stage.
An input at frequency 1,070 Hz drives the demodulator output voltage to a more positive voltage level.
PROBABILITY OF ERROR
The most important parameter that defines the efficiency of the modem is the probability of error and bit error rate.
BER means the amount of eror introduced in the transmited signal by the channel’s noise.
The expression for probability of error for this wireless data modem which uses non coherent FSK demodulation is given as
Pe=1/2*exp(-Eb/(2*N0))
ADVANTAGES OF FSK MODULATION
It rejects unwanted signals (noise) Automatic volume control methods
may be used to minimize the effects of signal fading.
SNR improvement of FSK over AM is approximately 3 to 4 dB.
Noise is eliminated in fsk reception. FSK may be satisfactory at nominal
power. The power ratio (fsk versus AM)
would become infinite in such a case.
APPLICATIONS OF FSK MODULATION
Telephone-line modems Caller ID Micro computers Audio cassettes Radio control Emergency Alert System shortwave radio station
THANK YOU