skill seteasy peasy

adjustable

For Infinity Bracelet

Design by: Tracy Gonzales

Instructions

www.tierracast.com

1

Simple, Stackable Style

1. Cut leather into two 7” pieces.

2. Thread the end of one cord

through one barrel bead, up

through hole at one end of focal

link, and back through barrel

bead.

3. Tie an overhand knot at end of

cord and tighten securely.

4. Adjust knot and bead so that they

are next to the focal link.

5. Repeat Steps 2-4 with second

piece of cord.

6. Thread loose ends of cords

through the third barrel bead from

opposite directions.

7. Tie an overhand knot at the end

of each cord and tighten securely.

8. Use flat nose pliers, crimping

pliers or hammer* to flatten the

barrel bead just enough to lightly

grip the cords and make the

bracelet adjustable.

TIP: Add a small drop of glue into the knots before final tightening.

9. Optional: Repeat Step 8 to secure

barrel beads in place next to the

focal link.

*Each tool will create a differenteffect on the bead.

fig 1

fig 2

Supplies 1 Infinity Link (94-3178-18)

3 4x2 Deco Barrel Beads

(94-5803-18)

14" 2mm round leather cord, brown

Required ToolsScissors, flat nose pliers, crimping

pliers or hammer, jeweler’s cement

Finished SizeAdjustable Bracelet

Watch our technique videos in

the DIY section of our blog

(look for videos on Opening and Closing Jump Rings, and

Crimping with Barrel Beads). TierraCast.com/blog/tag/diy