flex sensor
TRANSCRIPT
www.researchdesignlab.com Page 1
FLEX SENSOR 4.2
FLEX SENSOR
www.researchdesignlab.com Page 2
FLEX SENSOR 4.2
Table of Contents OVERVIEW ................................................................................................................................... 3
RELATED PRODUCTS ............................................................................................................ 8
www.researchdesignlab.com Page 3
FLEX SENSOR 4.2
OVERVIEW
INTRODUCTION
Flex Sensor 4.2" ROHS Compliant Description: A simple flex sensor 4.2" in length. As the
sensor is flexed, the resistance across the sensor increases. The resistance of the flex sensor
changes when the metal pads are on the outside of the bend (text on inside of bend). Connector
is0.1" spaced and bread board friendly. Note: Please refrain from flexing or straining this sensor
at the base. The usable range of the sensor can be flexed without a problem, but care should be
taken to minimize flexing outside of the usable range. For best results, securely mount the base
and bottom portion and only allow the actual flex sensor to flex.
FEATURES
Angle Displacement Measurement
Bends and Flexes physically with motion device
Possible Uses
Low profile
Simple construction
www.researchdesignlab.com Page 4
FLEX SENSOR 4.2
APPLICATIONS
Robotics
Gaming (Virtual Motion)
Medical Devices
Computer Peripherals
SPECIFICATIONS
Parameter
Value
Life cycle >1 million
Height <0.43mm
Temperature range -35C to +80C
WORKING The impedance buffer in the [Basic Flex Sensor Circuit] is a single sided operational amplifier,
used with these sensors because the low bias current of the op amp reduces error due to source
impedance of the flex sensor as voltage divider.
www.researchdesignlab.com Page 5
FLEX SENSOR 4.2
SCHEMATIC AND CODE
ARM
http://forum.researchdesignlab.com/FLEX%20SENSOR/ARM/FLEX.jpg
http://forum.researchdesignlab.com/FLEX%20SENSOR/ARM/FLEX.c
ATMEL
http://forum.researchdesignlab.com/FLEX%20SENSOR/ATMEL/FLEX.jpg
http://forum.researchdesignlab.com/FLEX%20SENSOR/ATMEL/FLEX.c
PIC
http://forum.researchdesignlab.com/FLEX%20SENSOR/PIC/FLEX.jpg
http://forum.researchdesignlab.com/FLEX%20SENSOR/PIC/FLEX.c
ARDUINO
http://forum.researchdesignlab.com/aurdunio/sensors/Flex%20sensor/Flex%20sensor.png
www.researchdesignlab.com Page 6
FLEX SENSOR 4.2
ARDUINO CODE
/*
* Project name:
FLEX Sensor
* Copyright
(c) Researchdesignlab.com
* Description:
* Test configuration:
MCU: ATMEGA328
Dev.Board: Arduino uno
Oscillator: 16 MHz
www.researchdesignlab.com Page 7
FLEX SENSOR 4.2
Software: Arduino
*/
int sensorPin = A0; // select the input pin for the flex sensor
void setup()
{
Serial.begin(9600); // set up the LCD's number of columns and rows:
}
void loop()
{
Serial.print(analogRead(sensorPin));
Serial.print(" ");
}
OUTPUT
www.researchdesignlab.com Page 8
FLEX SENSOR 4.2
RELATED PRODUCTS
PIC PROJECT BOARD PIC DEVELOPMENT BOARD
ATMEL PROJECT BOARD ATMEL DEVELOPMENT
BOARD