1

Ferrari California T Maxflo Exhaust System

Required Tools

Metric Socket Set w/ Ratchet & Extensions Metric Open-End Wrench Set

Torx Bits Inverted Torx sockets

CAUTION

• Always allow car to cool before performing any installation(s) or service(s) on it.• Always be sure to work on an even and level surface when raising vehicle(s) with a jack, and support all raised vehicles with locked

jack stands once elevated. • Fabspeed Motorsport recommends that all installations be supervised or verified by a trained professional technician. • Fabspeed Motorsport is not responsible for any personal injury or damage(s) sustained to a vehicle during installation of

aftermarket performance parts.

2

1. With the car raised on a lift or secured on jack stands, remove both rear wheels.

2. Using a T30 torx driver remove both rear wheel liners.

3

3. Using an inverted torx socket loosen the clamps securing the mufflers to the exhaust pipes.

4. Disconnect the vacuum lines to each muffler valve. 5. Using a 13mm wrench remove the cross brace connecting the left and right mufflers together. 6. Using a 13mm socket or wrench remove the exhaust hangers securing the mufflers to the vehicle. There will

be two hangers per muffler.

4

7. Remove the mufflers through the wheel well.

8. Install the exhaust hangers from the factory mufflers onto the Fabspeed mufflers. Note: Only the two outer

hangers are used with the Fabspeed mufflers. 9. Installation of the Fabspeed mufflers is reverse of removal. However, leave all hardware slightly loose until the

mufflers are installed. Align the tips within the bumper openings then tighten all hardware.

5

If you have any questions, comments, or concerns related to your product, please contact us!