evo x - throttle body - boombaracing.com x - throttle body.pdf · evo x - throttle body...

2
EVO X - THROTTLE BODY INSTALLATION MANUAL MATERIALS REQUIRED None 3 Remove the air filter housing. 4 Disconnect the throttle body wire harness. 5 Remove the air supply hose. 6 Disconnect the coolant lines and remove the throttle body. 7 Loop the coolant line back to the engine block. 8 Remove the throttle body cover. 9 Remove the spur gear. 10 Remove the servo motor and the wave spring. 11 Parts that will be reused with the Boomba Racing Throttle Body. 12 Place the wave spring inside of the throttle body housing. TOOLS REQUIRED M10 socket wrench M12 socket wrench Flat screw driver Phillips screw driver Pliers 6 mm Allen wrench T20 safety TOX 2 Remove the air filter assembly. 1 Disconnect the battery terminals.

Upload: lykien

Post on 22-Mar-2018

237 views

Category:

Documents


3 download

TRANSCRIPT

EVO X - THROTTLE BODY

INSTALLATION MANUAL

MATERIALS REQUIRED

None

3

Remove the air filter housing.

4

Disconnect the throttle body wireharness.

5

Remove the air supply hose.

6

Disconnect the coolant lines and removethe throttle body.

7

Loop the coolant line back to the engineblock.

8

Remove the throttle body cover.

9

Remove the spur gear.

10

Remove the servo motor and the wavespring.

11

Parts that will be reused with the BoombaRacing Throttle Body.

12

Place the wave spring inside of thethrottle body housing.

TOOLS REQUIRED

M10 socket wrenchM12 socket wrenchFlat screw driverPhillips screw driver

Pliers6 mm Allen wrenchT20 safety TOX

2Remove the air filter assembly.

1

Disconnect the battery terminals.

19

Repeat this process 3 (three) more timesto allow the ECU memorize new TPSsettings.

13Reinstall the servo motor and the spurgear. Install the throttle body cover.

14

Bolt the throttle body adaptor to the intakemanifold. Place the factory gasketbetween the adaptor and the manifold. 15

Bolt the throttle body to the manifold.Reconnect the air supply hose. Plug thewire harness connector. 16

Reinstall the air filter.

17

Reconnect the battery terminals.

18

Turn the ignition key to “ON” position.DO NOT START THE ENGINE.Wait for a minimum 20 seconds and turnthe ignition key to “OFF” position. Wait fora minimum 20 seconds.