eng new installation and commissioning warning...
TRANSCRIPT
Quick Start Guide
Warning DeviceLAL-**-GSM-Ex3
ENG
Document No.: 45-3081AEdition: 03/2010
Copyright Pepperl+Fuchswww.pepperl-fuchs.com
Pepperl+Fuchs GmbHLilienthalstrasse 20068307 Mannheim, GermanyTel. +49 621 776-0Fax. +49 621 776-1000
ImportantThe manual always takes priority over this quick start guide, which is only intended to provide a brief overview of the warning device functions. Refer to the manual for more detailed information about the warning device.
The corresponding safety chapter in this manual is an integral component of this document. Make sure the information in the safety chapter is read and understood.
Device Components
AntennaResetbutton
Send/Statebutton
New Installation and Commissioning
1 2 34 5 67 8 9
* 0 #
Insert the SIM card for the warning device in the cellular phone.
Change the PIN code on the SIM card to the default PIN code 1 2 3 4.
Further Confi guration
via cellular phone via SMS commands
1 2 34 5 67 8 9
* 0 #
Insert the SIM card in the warning device.
Insert the SIM card in the cellular phone.
Switch on the warning device.
Confi gure the SIM card. System OK / SMS fl ashes
Save the telephone number of the warning device. OWN +XXYYYYYYY
Sensor off
Save the telephone number of the fi rst recipient:PERSON1 +XXYYYYYYY
Alarm off
Save additional telephone numbers: PERSON2 +XXYYYYYYY PERSON3 +XXYYYYYYY
System OK/SMS LED fl ashes 80 to 100 times or for one minute.
System OK / SMS off
Sensor lights up
Alarm fl ashes
Insert the SIM card in the warning device.
Send an SMS command.
SET TIME
SET OWN +XXYYYYYYY
Switch on the warning device.Telephone number of the warning device
SET P1 +XXYYYYYYY
Telephone number of PERSON1Send additional telephone numbers for PERSON2 and PERSON3.System OK / SMS fl ashes
Sensor off
Alarm off
System OK/SMS LED fl ashes.Do not press any buttons during the start phase!
Normal indicationsystem OK
Indication if supply voltage too low
Indication after alarm or error
System OK / SMS lights up System OK / SMS off System OK / SMS off
Sensor off Sensor off Sensor lights up
Alarm off Alarm fl ashes once Alarm fl ashes 1 ... 5 times
1 x Battery voltage for warning device LAL-A8-GSM-Ex3 (battery version) is too low.
1 x Internal communication error – repairs required
2 x Network error – check transmission quality
Change the battery.Restart if necessary.
3 x SIM card missing or inactive – insert SIM card or load up calling credit (Prepaid SIM card)
4 x SIM card locked – check PIN code
5 x Telephone number for OWN or PERSON1 is missing or incorrect
Identify the cause, correct the errorRestart if necessary.
Oil Separator West
SQ: 5BL: 9.5 VDay: WEDTime: 10:28
Save the sensor confi guration
2
1
1
2
0 1 2 3 4 t
Oil Separator West
S1: OIL OKS2: LEVEL OKS3: SLUDGE OKSV: LOW
Always check to ensure that the sensor specifi cations in the received status message correspond with the actual confi guration.
Confi guration and Operating Instructions
Programming the SIM Card• Switch off the supply voltage before inserting or removing the SIM card.
• The warning device will not function and cannot be tested without a SIM card.
• When using your own cellular phone to confi gure the SIM card on the warning device, remember to store the information on the SIM card and not on the memory of the cellular phone.
• If you do not wish to confi gure the SIM card using a cellular phone, you have the option of using a USB SIM card reader for a PC.
• Always use uppercase letters, e. g., PERSON.
• Enter the corresponding country code in front of all telephone numbers (+44 for United Kingdom, +49 for Germany, etc.). Do not enter a space, 0 or 00 in front of the country code.
• Do not include any spaces or special characters in telephone numbers.
• Enter (a minimum of) PERSON1 with corresponding telephone number in the telephone book on the warning device SIM card orPERSON1 and PERSON2 orPERSON1, PERSON2 and PERSON3
Never program PERSON2 without any details.
Changing the Battery for LAL-A8-GSM-Ex (Battery Version)• Press the State/Send button for approx. 3 seconds after removing the old but
before inserting the new battery.
Test Mode• If an LAL9-D-Ex sludge level sensor is connected, TestMode appears when the
fi rst SMS message is sent to the warning device. In test mode, the sludge level sensor responds immediately when an alarm status is active.
• Test mode remains active for about 10 minutes, after which the warning device switches back to normal mode automatically. Test mode can be activated for checking purposes, for example, by sending the SMS command SET TEST ON. Send the SMS command SET TEST OFF to deactivate test mode.
Sen
sor
1
Sen
sor
2
Sen
sor
3
LAL-A6-GSM-Ex3 230 V ACLAL-A8-GSM-Ex3 BatteryLAL-D2-GSM-Ex3 12 V DC ... 30 V DC
Power supply:
SIM card
LED indicator
System OK / SMS
Sensor
Alarm
LED Indicator
The LEDs do not light up.
System OK / SMS off
Sensor off
Alarm off
The warning devices LAL-A8-GSM-Ex3 (battery version) and LAL-D2-GSM-Ex3 (DC version) are operating in sleep mode (energy-saving).
Press the State/Send button for approx. 4 seconds. The current status is displayed.
No active alarms or errors
System OK / SMS lights up
Sensor off
Alarm off
SMS message sent System OK / SMS flashes once
Sensor off
Alarm off
Previous alarms or errors
System OK / SMS flashes
Sensor off
Alarm off
An alarm or error occurred previously – identify the cause, correct the error.
Briefly press the Reset button once. System OK/SMS LED lights up.
Communication via SMS
1 2 34 5 67 8 9
* 0 #
Status of SensorsSEND SSTATUS
Oil Separator West
S1: OIL OKS2: LEVEL OKS3: SLUDGE OKSV: LOW
S1, S2, S3 Sensor 1, sensor 2 and sensor 3
SV Supply voltage OK or LOW (only on warning device LAL-A8-GSM-Ex3 (battery version))
Status of the Warning DeviceSEND DSTATUS
Oil Separator West
SQ: -81 dBmBL: 9.14 VDay: THUTime: 07:09TestMode
SQ Signal strength 2 ... 10 (best value 10) orSignal strength -50 dBM ... -100 dBM (best value -50 dBM)
BL Battery voltage (only on warning device LAL-A8-GSM-Ex3 (battery version))
Day Displays the day when the SMS message was sent
Time Displays the time when the SMS message was sent
TestMode only when sludge level sensor LAL9-D-Ex is connected
Current ConfigurationSEND SETUP
Oil Separator West
OWN: +4940496097PERSON1: +4930941335PERSON2: +49178155054MDELAY: 0STATUS: WED. 12:00
OWN Telephone number of the warning device
PERSON1 Telephone number of PERSON1
PERSON2 Telephone number of PERSON2
PERSON3 Telephone number of PERSON3
MDELAY
Measured delay in sleep mode (energy-saving) (only with warning devices LAL-A8-GSM-Ex3 (battery version) and LAL-D2-GSM-Ex3 (DC version)); 0, 5, 10 ... Minutes
STATUS Time of the continuous status message, day of the week and time specified
Setting the TimeSET TIME
Oil Separator West
OWN: +4940496097PERSON1: +4930941335PERSON2: +49178155054MDELAY: 0STATUS: WED. 12:00
Adjust the time on the warning device (e. g., when changing to daylight saving time)
SMS Counter Overflow
Oil Separator West
SMS LIMIT ERROR
More than 5 SMS messages/hour. The warning device stops sending SMS messages. Reset the SMS counter with:
RESET SMS COUNTER
Alarm or error indication for sensors
System OK / SMS off
Sensor flashes 1 ... 3 times
Alarm flashes 1 ... 3 times
Sensor LED
1 x Sensor 1
2 x Sensor 2
3 x Sensor 3
Alarm LED
1 x Sensor in alarm
2 x Sensor error
3 x Communication error between sensor and warning device
The oil/petrol separator, sensor and associated installation must be checked and repaired or replaced if necessary.
Fault indication for SIM card or warning device
System OK / SMS off
Sensor lights up
Alarm flashes 1 ... 5 times
1 x Internal communication error – repairs required
2 x Network error – check transmission quality
3 x SIM card missing or inactive – insert SIM card or load up calling credit (Prepaid SIM card)
4 x SIM card locked – check PIN code
5 x Telephone number for OWN or PERSON1 is missing or incorrect
Identify the cause, correct the error
Battery or SMS warning
System OK / SMS off
Sensor off
Alarm flashes once or twice
1 x Battery voltage for warning device LAL-A8-GSM-Ex3 (battery version) is too low – change the battery
2 x SMS limit error – Identify the cause, correct the error, reset the SMS counter
Briefly press the Reset button once. The SMS counter is reset.