electrical hardware
TRANSCRIPT
Electric Wiring Hardware
Identification
Electric Wiring Hardware
IdentificationBy
Dave Wilson
Information Technology and Communication ServicesITCS Instructional Materials
College of Agricultural, Consumer and Environmental SciencesUniversity of Illinois at Urbana-Champaign
Copyright ® 2002 - University of Illinois Board of TrusteesCAD
Boxes
Octagon box with clamps
Square box
Switch box with clamps for NM cable
Conduit switch box
Handy box (surface mounted metallic box)
Nonmetallic device box for wall mounting with ENT conduit
Nonmetallic conduit box, device
Cable
Multiplex cable, ACSR
SE (service entrance) cable
UF (underground feeder) cable
NM (nonmetallic sheathed) cable2 wire with ground
NM (nonmetallic sheathed) cable3 wire with ground
Conduit
Rigid metallic conduit
EMT conduit (electrical metallic tubing or thin wall conduit)
Rigid nonmetallic conduit (PVC)
Flexible metallic conduit
Liquidtight flexible metal conduit
Liquidtight flexible nonmetallic conduit
Rigid metallic conduit locknut
Connectors
Service cable connector
Nonmetallic, liquidtight connector for UF cable
Rigid nonmetallic conduit connector
Metallic, liquidtight connector for UF cable
Liquidtight flexible nonmetallic conduit connector
Metallic connector for NM cable
Solderless wire connector (wire nut)
Grounding clip
Split-bolt connector (wire splice)
Cord Equipment
15 ampere, grounding type 120 volt dead front attachment plug (plug cap)
Covers
Metallic Handy Box cover for toggle switch
4” square box raised cover for 2 toggle switches
Nonmetallic weatherproof switch cover for device box
Nonmetallic watertight toggle cover for device box
Nonmetallic weatherproof duplex receptacle cover
4” square box raised cover for duplex receptacle
Metallic Handy Box cover for duplex receptacle
Blank cover for 4” square box
Blank cover for 4” octagon box
Lampholders
4” porcelain keyless lampholder
Nonmetallic, globed weatherproof lampholder for round box
Nonmetallic, globed watertight lampholder
Metallic weatherproof lampholder for round box
Receptacles
Grounding type duplex receptacle 15A-125V
Grounding type duplex receptacle 20A-125V
Grounding type duplex receptacle 20A-250V
Combination 15A-240V and 120V receptacle
Grounding type single receptacle 20A-125V
Ground fault circuit interrupter (GFCI) receptacle
GFCI plug-in receptacle
Single grounding type receptacle with fuseholder
30 amp 240V surface mount receptacle (dryer receptacle)
50 amp 240V surface mount receptacle (range receptacle)
Service Equipment
Ground rod
Bronze clamp for 5/8” ground rod
Ground clamp for ground rod and water pipe
120 V breaker 20 amps
120V ground fault circuit interruptor (GFCI) breaker
240 V breaker
Switches
Single-pole toggle switch (SPST)
Single-pole switch with pilot light
Single-pole toggle switch, glow handle
Single-pole toggle switch, lighted handle
Three-way toggle switch (SPDT)
Four-way toggle switch (DPDT)
Combination (2) single-pole switches
Combination 3-way switch and single receptacle
Combination single-pole switch and receptacle
Wall Plates
Single-gang wall plate for toggle switch
Single-gang wall plate for duplex receptacle
Watertight wall plate for duplex receptacle
Two-gang wall plate for toggle switch
Two-gang wall plate for toggle switch and receptacle
Miscellaneous
Cable clamp
Cable strap
Metallic conduit strap
Nonmetallic strap for 3/4” PVC conduit
End of Show
Quit
ITCS Instructional MaterialsCollege of Agricultural, Consumer and Environmental SciencesUniversity of Illinois at Urbana-Champaign
This set of images was photographed by Cindy Lamb-Basham and Dave Wilson. The presentation was reviewed by Dr. Joe Harper, Department of
Agricultural Engineering at the University of Illinois
University of Illinois1917 South Wrigth Street
Champaign, IL 61820(800) 345-6087
www.aces.uiuc.edu/ITCS/IM