economic selection of type of genration and types of equipment used in power plant
TRANSCRIPT
![Page 1: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/1.jpg)
APRESENTATION
ON
ECONOMIC SELECTION OF TYPE OF GENERATION
&TYPES OF EQUIPMENT
PRESENTED BY
Madhusudan sharmaFinal year, Electrical engineering
![Page 2: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/2.jpg)
INTRODUCTION
In all engineering works question of cost is of first importance. While designing electrical power generating stations and other systems efforts are made to achieve overall economy so that the per unit cost of generation is the lowest possible. This will enable supplier to supply electrical energy to its consumers at reasonable rates.
In every system, economy plays an important role. A saving in cost of generation of electrical power represents a significant reduction in the operating cost as well as fuel cost. The electrical engineer has to adopt a cheapest and most convenient scheme.
![Page 3: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/3.jpg)
PLANT LOCATION AND SITE SELECTON
1. Raw material availability.2. Location (with respect to the marketing area.)3. Availability of suitable land.4. Transport facilities.5. Availability of labors.6. Availability of utilities (Water, Electricity).7. Environmental impact and effluent disposal.8. Local community considerations.9. Climate.10. Political strategic considerations.11. Taxations and legal restrictions
![Page 4: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/4.jpg)
PLANT LAYOUT
Thus the economic construction and efficient operation of a process unit will depend on
how well the plant and equipment specified on the process flow sheet is laid out. The
principal factors that are considered are listed below:
![Page 5: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/5.jpg)
CONTINUE......
1. Economic considerations: construction and operating costs.2. Process requirements.3. Convenience of operation.4. Convenience of maintenance.5. Health and Safety considerations.6. Future plant expansion.7. Modular construction.8. Waste disposal requirements
![Page 6: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/6.jpg)
SELECTION OF TYPES OF EQUIPMENT
Selection of boilers
Super heaters
Economizer and air pre-heater
Condenser
Prime-movers
Selection of size and number of generating units
![Page 7: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/7.jpg)
SELECTION OF BOILERS
“Boiler or steam generator basically convert water into steam.”
Boilers are of two types-1. Fire tube boilers2. Water tube boilers Advantage of water tube boiler over gas tube boiler-a) High evaporation capacity due to large heating surface.b) High pressure due to small size of drum.c) Safe in operation.d) Occupy less space.
![Page 8: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/8.jpg)
SUPER HETERS AND REPEATERS
“A superheater is a device which removes the traces of moisture from saturated steam and helps in increasing the temp. of steam.”
Superheater is used in plant to increase the efficiency of plant by-
1. As the steam is dry , turbine blades remain dry so mech. Resistance is less.
2. Due to dryness of steam no corrosion occurs on blades of turbine.
![Page 9: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/9.jpg)
ECONOMIZER AND AIR PRE-HEATER
Economizer and air pre-heater are devices which recover the heat from the flue gases on their way to chimney and raise the temp. of feed water and air supply for combustion.
Economizer raise the boiler efficiency by (10-12%) and saves the fuel consumption by (5-10%).
![Page 10: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/10.jpg)
CONDENSER
Condenser are used to condense the exhaust steam and it also removes air and other non-condensable gases from steam.
There are of two types- Jet or contact condenser Contact condensers In modern power plants mostly surface condensers
are used because in this condensate can be used as a feed water to the boiler.
![Page 11: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/11.jpg)
PRIME-MOVERS
“Prime movers are used to convert the stored energy into rotational mechanical energy”
While selecting a prime-mover the initial cost of plant taken into consideration. As the efficiency of plant increases but there is a reduction in the floor space of plant.
For industrial purpose non condensing type and for central generation condensing type steam turbine should be used.
![Page 12: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/12.jpg)
SELECTION OF SIZE AND NUMBER OF GENERATING UNITS
Selection of units and their operation plays an important role in the working of power station and economics of power generation.
The size and number of units is decided from the load curves.
![Page 13: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/13.jpg)
ANDFACTORS AFFECTING THE SIZE NO. OF UNITS IN A GENERATING
STATION Demand of power Max. efficiency Growth of demand in near future Capacity of plant should be 15 or 21% more than
the expected maximum demand.
![Page 14: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/14.jpg)
ADVANTAGE OF LARGE SIZE UNIT
Large size units are more beneficial than small size units because-
Less floor area Less operating labor Less maintenance Better efficiency
![Page 15: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/15.jpg)
DISADVANTAGE OF SELECTING LARGE UNIT
During the day sometimes the load on the system is much less than the peak load, so the unit running at that time does not give the max. efficiency and generation cost per unit should increase.
In case of complete failure or supply due to breakdown on maintenance.
![Page 16: Economic selection of type of genration and types of equipment used in power plant](https://reader036.vdocuments.us/reader036/viewer/2022062522/589be6011a28aba5108b6851/html5/thumbnails/16.jpg)
THANKS
@ MR. UNIQUE PRESENTATIONS