ECE 1201

Engineering Lab II

Taaruf• Nor Farahidah Za’bah• Room number : E2-2-13.12• Phone number : 03-61964562• Email address : adah510@iium.edu.my• The lab technicians are– Br. Ahmad Suhairi and Br. Rosley Mahadi

• Course website:• http://staff.iium.edu.my/asuhairi/koe/

Tentative Week Experiment No. (Title)1 Introductory class – Briefing on the organization of the course2 Introduction to PSPICE 3 PSPICE

4Experiment No. 1 & 2

(Diode Characteristics & Zener Diode Characteristics)

5 & 6Experiment No. 3

(Wave Rectifier & Clipper Circuit)

7 & 8Experiment No. 4

(BJT Characteristics & Common-Emitter Transistor Amplifier)

9 & 10Experiment No. 5

(BJT Biasing Circuits)

11Experiment No. 6

(MOSFET - Common Source Amplifier)

12Experiment no. 7

(Inverting and Non-Inverting OP Amp)

Pre-lab 10 %

Quiz 15 %

Final Test 30 %

Lab Report 45 %

Assessment

Safety

• Please wear Kulliyyah jacket and covered shoes – NO SLIPPER. Otherwise, you will be asked to leave the lab.

• Power must be switched off whenever an experiment or project is being assembled, disassembled, or modified.

Tidiness

• When the experiment has been satisfactory completed and the results approved by the instructor, the students may disconnect the circuit and return the components and instruments to the locker tidily.

• Chairs are to be slid in properly. • DO NOT WRITE anything on the table

Pre-Lab Questions and Preparation

• Please complete the pre-lab questions before each lab sessions.– It serves as guidance for you while doing your experiment

• Read the entire experiment and research any required theory beforehand. Many times an experiment takes longer that one class period simply because a student is not well prepared.

• The experiment is performed in pairs (max=3 students per group) but the final exam is performed individually– One group = one lab report

Lab Reports

• Reports have to be handwritten for submission.– Writing should appear on one side of each sheet only.– The students’ name & matric number, section number,

lab session and the lecturer’s – Please indicate the author of each section in your report.

• This must be followed in the middle of the sheet by:– The course code– The experiment number– The title of the experiment – The date on which the student carried out the experiment.

Report format and evaluation

Tentative Week Experiment No. (Title)1 Introductory class – Briefing on the organization of the course2 Introduction to PSPICE – Tutorial 13 PSPICE - Tutorial 2

• Please download the PSPICE software and its tutorial from the website into your laptop.

• One group will need only need one laptop

Preparation for PSPICE Tutorial

Preparation for PSPICE Tutorial

• Download 16.6_OrCAD_Lite_Capture&PSpice_Products.zip from the any computer in the lab– It is a zipped file, you have to extract the files into a

designated folder– Once you have extracted, go to Disk 1 and look for

SETUP (it is an application file) to install the software.

Introduction to Lab Equipment• Bread board and its connections

• Function Generator– To create AC signals such as Sine-Wave, Triangular

Waves etc– The user can alter its frequency and amplitude

Example of a function generator

• Oscilloscope– An equipment to show the obtained result.– Has 2 channels• One for input signal• One for output signal

• DC power supply– To provide DC supply to your circuit which you can

measure using digital multimeter