drug delivery and mass balance bioe201-b. the concentration of the drug at the site of action, over...

Download Drug Delivery and Mass Balance BIOE201-B. The concentration of the drug at the site of action, over time. Drug delivery is about the complex mechanisms

If you can't read please download the document

Upload: violet-potter

Post on 22-Dec-2015

213 views

Category:

Documents


2 download

TRANSCRIPT

  • Slide 1
  • Drug Delivery and Mass Balance BIOE201-B
  • Slide 2
  • The concentration of the drug at the site of action, over time. Drug delivery is about the complex mechanisms to getting that concentration profile to happen. Delivery methods can be classified by the anatomical site they target (oral, injection, topical, transdermal, pulmonary, ophthalmic, rectal/vaginal, implantable depot device, etc.). Drug Delivery and Mass Balance
  • Slide 3
  • OralAdministration IntravenousInjection IntramuscularInjection SubcutaneousInjection GastrointestinalTract CirculatorySystem Tissues MetabolicSites Excretion
  • Slide 4
  • Even with controlled delivery side effects cannot be avoided Might cause severe side effects- spread over body Site specific delivery- active or passive targeting
  • Slide 5
  • RES Lungs Liver Spleen Reticuloendothelial System (RES) Site Specific Delivery
  • Slide 6
  • Enhanced permeability and retention (EPR) effect Disorganization of tumor vasculature Poor lymphatic drainage Passive Targeting of Particulate by EPR Mechanism
  • Slide 7
  • Ringsdorfs Model Active Targeting
  • Slide 8
  • Various Drug Delivery System
  • Slide 9
  • Chemically-Controlled DDS
  • Slide 10
  • Major Classes of Matrix in DDS
  • Slide 11
  • Environmentally Responsive System
  • Slide 12
  • pH Responsive System
  • Slide 13
  • Absorption of drugs could vary within different administration routes 500 mg dose given intramuscularly orally **to the same subject on separate occasions Biological barriers greatly affect the extent of drug absorption
  • Slide 14
  • Absorption of drugs could vary within the same administration route
  • Slide 15
  • Slide 16
  • Drug Delivery System (DDS) Controlled delivery system Site specific delivery of drugs Toxicity Therapeutic Window No Therapeutic Effect
  • Slide 17
  • Time (min) Plasma concentration (mg/mL) Unsuccessful therapy Successful therapy
  • Slide 18
  • All drugs must diffuse through various barriers when administered to the body. Some drugs must diffuse through the skin, gastric mucosa, or some other barrier to gain access to the interior of the body. Parenteral drugs must diffuse through muscle, connective tissue, and so on, to get to the site of action. Intravenous drugs must diffuse from the blood to the site of action. Drugs must also diffuse through various barriers for metabolism and excretion. Laws governing diffusion are important to drug delivery systems
  • Slide 19
  • Ficks law for diffusion, compartmental analysis, and the general use of mass conservation equations. The mass conservation equation: In out + Generation - Consumption = Accumulation This equation, when properly replaced with mathematical terms, is used to describe transport everywhere. We can use simplified experiments and model fitting to calculate the value of drug diffusion constants, which can then be used to predict concentration profiles in relevant drug delivery scenarios.
  • Slide 20
  • Bioavailability is defined as a ratio of the areas under the curves (AUCs) of plasma concentration versus time. The AUC for intravenous injection is the standard, and any other delivery method is compared against that. Bioavailability and Area Under the Curve
  • Slide 21
  • Important Concepts Volume of distribution apparent volume into which a drug distributes in the body at equilibrium direct measure of the extent of distribution V = amount of drug in the body/Plasma drug concentration
  • Slide 22
  • Mathematical Modeling of Drug Disposition Single compartment Single compartment with absorption Two compartments Two compartments with absorption Physiological Models
  • Slide 23
  • These compartments don't usually correspond to actual bodily compartments, but they're still useful. The simplest case is the singlecompartment model. All the compartments are considered to be uniform and wellmixed. Compartmental analysis In cases where the drug doesn't readily distribute to the whole body immediately, it's better to model things with more than one model. For example, using two of them:
  • Slide 24
  • Single Compartment Model Assumptions: Body one compartment characterized by a volume of distribution (V d ) Drug is confined to the plasma (small V) C, V d absorption elimination k, C t C/C 0
  • Slide 25
  • One-Compartment Model with Absorption Low absorption occurs Absorption is the rate- limiting step Slow absorption may represent drug entry through GI tract or leakage into circulation after SC injection Drugs require multiple doses to maintain drug concentration within therapeutic window t M/D 0 t
  • Slide 26
  • Two-Compartment Model Drug rapidly injected Drug distributed instantaneously throughout one compartment and slowly throughout second compartment Describes drug concentration in plasma injected IV C 1, V 1 C 2, V 2 k 2, C 2 k 12 k 21 k 1, C 1 Compartment 1 Compartment 2 tt Concentration after ingestion Concentration with slow absorption C/C 0
  • Slide 27
  • Diffusion occurs when individual molecules move within a substance, as the result of a concentration gradient or by random molecular motion. Molecular diffusion from a microscopic and macroscopic point of view. Initially, there are solute molecules on the left side of a barrier (purple line) and none on the right. The barrier is removed, and the solute diffuses to fill the whole container. Top: A single molecule moves around randomly. Middle: With more molecules, there is a clear trend where the solute fills the container more and more uniformly. Bottom: With an enormous number of solute molecules, randomness becomes undetectable: The solute appears to move smoothly and systematically from high- concentration areas to low-concentration areas. This smooth flow is described by Fick's laws. Ficks Law
  • Slide 28
  • Ficks first law relates to a steady-state flow J = dM/(S dt)= -DdC/dX J = Flux (in g/cm 2 s) M = material (in g) S = surface area (in cm 2 ) t = time (in s) D = diffusion coefficient (in cm 2 /s) C = concentration (in g/cm 3 ) X = distance of movement (in cm) units: g/cm^2*s Steady State Diffusion Ficks second law relates to a change in concentration of drug with time, at any distance, or an unsteady state of flow. J= -D*(C1-C2)/h D = diffusion coefficient (in cm 2 /s) C = concentration (in g/cm 3 ) h = thickness of membrane (in cm) Non-Steady State Diffusion Partition Coefficient K=C1/Cd=C2/Cr K=[Drug]oil/[Drug]water determines concentration of drug in the membrane
  • Slide 29
  • 29 A Versatile Prodrug Platform API= ACTIVE PHARMACEUTICS INGREDIENT SN-2
  • Slide 30
  • 30g/kg x 3 times (3, 6, 9 days) BiomaterialsBiomaterials, 2012, 33 (33), 8632864033 (33 Pan et. al. Nanomedicine (UK), 2012 Treated Un-treated AntiAngiogenic Therapy Pan et. al. Circulation. 2009, 120, S322. Comparison of MR Contrast Enhanced Images presented as 2D Slice and 3D Volume THERAPY NO THERAPY
  • Slide 31
  • Theranostic 2014