drive test1
TRANSCRIPT
-
8/6/2019 Drive Test1
1/13
Drive Test and Radio
optimization for UMTS/GSM
NetworksBMCSAT Company
-
8/6/2019 Drive Test1
2/13
www.bmcsat.com 2
Contents
Introduction
Site verification of radio parameters Network performance checking in static positions
Network performance checking in mobile positions
Area Drive test verification
Drive test analysis & recommendations
Case Studies
-
8/6/2019 Drive Test1
3/13
www.bmcsat.com 3
Our company specialized in radio telecommunication puts underyour disposition our skills and experiences concerning:
- Site verification radio parameters
- Drive test data
- Analysis and recommendations in order to optimize the
performance of our network
We perform testing for 2G and 3G networks (GSM/GPRS/EDGE/UMTS/R99/HSDPA/HSUPA)
We use Nemo tools in drive test data
Introduction
-
8/6/2019 Drive Test1
4/13
www.bmcsat.com 4
Site verification of radio parameters (1)
Hardware Checking
For each cell, we choose one location close the BTS. The target Cellshould be in the Light of Sight.
The following items should be checked approximately:
Antenna Azimuth
Antenna Tilt
Note: This test should be repeated for each Sector
-
8/6/2019 Drive Test1
5/13
www.bmcsat.com 5
Network Checking
For 2G Network Check, we could collect the information below using
an IDLE UE locked in 2G mode : Frequency BCCH BSIC Cell ID
LAC/RAC For 3G Network Check, we may collect the information below using
an IDLE UE locked in 3G mode : Frequency Primary Scrambling Code Cell ID LAC/RAC
Site verification of radio parameters (2)
-
8/6/2019 Drive Test1
6/13
www.bmcsat.com 6
Network performance checking in static positions
For 2G Service Check, we could do the following tests using a UElocked in 2G mode
Mobile originated calls, Mobile terminated calls, EDGE FTPDownload, EDGE FTP Upload
For 3G Service Check, we are able to do the following tests using aUE locked in 3G mode
AMR originated call, AMR terminated call R99 FTP download, R99 FTP Upload HSDPA FTP download and HSUPA FTP Upload
-
8/6/2019 Drive Test1
7/13
www.bmcsat.com 7
For 2G Service Check, we use 2 UEs and one GPS in order toexecute the long and short calls tests.
For 3G Service Check, we use 2 UEs in order to execute the AMRlong and short calls and data transfer.
Note: the test should be made Clockwise and anti clockwise
Network performance checking in mobile positions
-
8/6/2019 Drive Test1
8/13
www.bmcsat.com 8
Area Drive test verification
After site verification of radio parameters, its possible to perform Drivetest in global area in order to optimize the radio performance (detectcall drops, Handover Failures, Call set up Failures and resolve theseproblems)
For 2G Service Check, the following tests will be considered: 2G Long and Short call
Automatic Long call (2G and 3G) EDGE FTP Download MOS
For 3G Service Check, the following tests will be considered: 3G short and Long call R99 FTP download HSDPA & HSUPA FTP transfer MOS
-
8/6/2019 Drive Test1
9/13
www.bmcsat.com 9
Drive test analysis & recommendations
Statistics collections 2G & 3G Analysis
2G & 3G recommendations & solutions about radio problem
- Design tuning (Az, Tilt,)
- Add neighbors / - Frequencies modifications
-
8/6/2019 Drive Test1
10/13
www.bmcsat.com 10
Case Studies
2G Analysis: Quality, Signal Level, Handover Failures and Call drops
-
8/6/2019 Drive Test1
11/13
www.bmcsat.com 11
Case Studies
3G Analysis: EcNo, RSCP, Handover Failures and Call drops
-
8/6/2019 Drive Test1
12/13
www.bmcsat.com 12
Contacts
For more information you can contact us at the
following:
Electronic addresses www.bmcsat.com
Phone number +216 25 306 116
-
8/6/2019 Drive Test1
13/13
www.bmcsat.com 13