OMNTEC Mfg., Inc., 1993 Pond Road, Ronkonkoma, NY 11779 Phone (631) 981-2001 Fax (631) 981-2007 www.OMNTEC.com
File Name: DI00025 rev1523.doc Page 1 of 1 Rev Date: 6-4-2015
XB‐RB8 Relay Interface Board Installation Dry contacts rated at 120VAC @ 5 amps resistive
2. Insert XB‐RB8 interface board into designated card slot in OEL8000III.
To program relay trigger points refer to the OEL8000III Programming Manual
NOTE: Once a card is programmed, moving it to a different slot may require reprogramming of card.
3. Attach removable connectors to XB‐RB8 (The XB‐RB8 should already be inserted into the card slot in the OEL8000III).
1. Attach wires to the top of the removable connector. XB‐RB8 In an energized unalarmed state: (Defaulted in failsafe mode, non‐failsafe mode will reverse all N.O. and N.C. contacts.)
Relay Outputs #1 ‐ #4 1 ‐ Normally Closed 2 ‐ Common R1 3 ‐ Normally Open
4 ‐ Normally Closed 5 ‐ Common R2 6 ‐ Normally Open
7 ‐ Normally Closed 8 ‐ Common R3 9 ‐ Normally Open
10 ‐ Normally Closed 11 ‐ Common R4 12 ‐ Normally Open
Relay Outputs #5 ‐ #8 1 ‐ Normally Closed 2 ‐ Common R5 3 ‐ Normally Open
4 ‐ Normally Closed 5 ‐ Common R6 6 ‐ Normally Open
7 ‐ Normally Closed 8 ‐ Common R7 9 ‐ Normally Open
10 ‐ Normally Closed 11 ‐ Common R8 12 ‐ Normally Open
WARNING
Remove all power to the controller and to all wires entering the controller panel before doing any installation or servicing. Failure to comply will create an electric shock or explosion hazard that can result in death, personal injury, or property damage.
XB‐RB8 SIDE VIEW
SLOT #7 SLOT #1
INSIDE PROTEUS X
N.O
.
N.C
.
Com
.
1 2 3 4 5 6 7 8 9 10 11 12
N.O
.
N.C
.
Com
.
N.O
.
N.C
.
Com
.
N.O
.
N.C
.
Com
.
N.O
.
N.C
.
Com
.
1 2 3 4 5 6 7 8 9 10 11 12
N.O
.
N.C
.
Com
.
N.O
.
N.C
.
Com
.
N.O
.
N.C
.
Com
.
CONNECTOR RELAY OUTPUTS #1 ‐ #4 CONNECTOR RELAY OUTPUTS #5 ‐ #8
CONNECTOR SIDE VIEW CONNECTOR FRONT VIEW
XB‐RB8 FRONT VIEW
1 2 3 4 5 6 7 8 9 10 11 12 1 2 3 4 5 6 7 8 9 10 11 12
