-
7/29/2019 Surge Protector - Installation Instruction Type PI 3_3 MCB BS (http://shop.acdc-dcac.eu/)
1/4
Sur e ProtectionG
Surur eMULTI-STAGE SURGE PROTECTION
Empowered by Innovation
Installation and Operating Instruction
ACDC Surge Protectors Type - PI (780; 7100; 7125; 7200) 3/3 - MCB - BSEIGHT (8) STAGES 1/1 & 3/3SERIES PROTECTOR
Cascade bi-directional EMI-RFI filtering of phase (L) and ground (GND) wire
CLASSCLASSI+II+IIII+II+III 200 homeome telecomelecom industryndustrycenterenterITT
IPIP3300 11 22
LPZLPZ
Single Phase & Three Phase CLASS I+II+III
Hard Wire Installation - Modular System
Type - PI (780; 7100; 7125; 7200) 3/3- MCB - BS
Indication for bed grounding, remote alarm
www.acdc-dcac.eu
-
7/29/2019 Surge Protector - Installation Instruction Type PI 3_3 MCB BS (http://shop.acdc-dcac.eu/)
2/4
Mounting of ACDC Surge Protectors
ACDC Surge Protecto rs - Bl ue Series h ave to be ins ta ll ed at E NT RY POI NT th e Ma in Dist ribution B oard s ( MDB )
or internal Sub Distribution Boards (SDB) right in front of the input power to the device that should be protected The ACDC Surge Protectorcould be install in series or parallel configuration depending of total load per phase (>100A
-
7/29/2019 Surge Protector - Installation Instruction Type PI 3_3 MCB BS (http://shop.acdc-dcac.eu/)
3/4
L1
INPUT AC
L2 L3 N Gnd L1 L2 L3 N Gnd
up to
CircuitBreaker 100A C
up to
100A C
up to
100A C
N Gnd
TerminalBlocks
L1 L2 L3 N Gnd
OUPUT AC
Installation Instruction
MULTI-STAGE SURGE PROTECTION Surur e
Integrated Multi-Stage Protection
Installation Instruction
Installation Instruction for Type - PI (780; 7100; 7125; 7200) 3/3 - MBS - BS
The Surge Protectors are installed in Metal Distribution board with degree of protection IP54
Circuit breakers MCB 100A are installed in the front of protectors for each phase
CAUTION
This equipment must onlybe installed and servicedby qua l i f i ed e lec t r i c a lp e r s o n n e l .
T u r n o f f a l l p o w e r supplying this equipmentbefore working on or insidee q u i p m e n t .
During installation into anelectrical system, it mustnot be energized unt i lcompletely inspection.
.
.
Failure to follow theseinstructions will resultin serious injury.
HAZARD OF ELECTRICSHOCK, EXPLOSION, ORARC FLASH
DANGER
*
for
or
The Surge Protectors from series Type-PI 3/3-MBC-BS are delivered without ground filtering as model basic option.
By customer request the model could be delivered for installation with ground filtering or parallel installation
with additional mark GF P
www.acdc-dcac.eu
-
7/29/2019 Surge Protector - Installation Instruction Type PI 3_3 MCB BS (http://shop.acdc-dcac.eu/)
4/4
MULTI-STAGE SURGE PROTECTIONSurur eOperation
Diagnostic System
ACDC DCAC Dan e Kr apc ev n o.2/1, 1000-Skop je , Mac edo ni a Phon e: 389 2 3216 9 88; Fax : 389 2 3216 993ACDC DCAC Dan e Kr apc ev n o.2/1, 1000-Skop je , Mac edo ni a Phon e: 389 2 3216 9 88; Fax : 389 2 3216 [email protected]
Every ACDC Surge Protector Type -PI (740; 780; 7125; 7200) Blue Series have free contact alarm as basic option. The alarm is activate in two cases:
1. When some of the protection stages (2, 4 or 6) are damaged or burned and Red Led is ON. Alarm contacts 1-3 are permanently closed.
2. When the ground of the power grid system is not well performed (pour groun ding). Alarm contacts1- 3 are closing with frequency of 2Hz (0,5s)
Red led is blinking.
Free contacts are on the cover of the protector w ith contact no. 1 and 3. (see picture)The contact is a optocoupler with maximum value of voltage 70VDC and current of 10mA. In normal condition it is open.
.
.
1 3N.C
+-
Free Contact Alarm
ND IV,VIIIG
1, 3 and 7 Stage: Filter (bi-directional wave tracking);, 3 and 7 Stage: Filter (bi-directional w ave tracking);3dB-3kHz,38dB-100kHz,50dB-300kHz; 50bB-500kHzdB-3kHz,38dB-100kHz,50dB-300kHz; 50bB-500kHz2, 4 and 5 Stage: Surge Limiter (L-N), 4 and 5 Stage: Sur ge Limiter (L-N)150kA (8x2050kA (8x20 s); 22kA (10/350); 22kA (10/350 s))6. Stage: MOSFET Limiter-500A (8x20. Stage: MOSFET Limiter-500A (8x20 s)(RT