Download - relay protection
![Page 1: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/1.jpg)
SEMINAR ON
Protection and Relay Schemes
Presented By:- Pranav Nema M.Tech. (Power System) I semScholar no.- 072113110
![Page 2: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/2.jpg)
Contents
Introduction of Protective Relays Relay purpose Types of relays Advantage & disadvantage Why a system needs protection Types of fault Protective device comparison Protection & relay scheme 1) Motor protection 2) Transformer protection 3) Generator protection Conclusion
![Page 3: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/3.jpg)
What are Relays?
Relays are electrical switches that open or close another circuit under certain conditions.
![Page 4: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/4.jpg)
Relay Purpose
Isolate controlling circuit from controlled circuit.
Control high voltage system with low voltage.
Control high current system with low current.
Logic Functions
![Page 5: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/5.jpg)
Relay Types
Electromagnetic Relays (EMRs) EMRs consist of an input coil that's wound to accept a
particular voltage signal, plus a set of one or more contacts that rely on an armature (or lever) activated by the energized coil to open or close an electrical circuit.
Solid-state Relays (SSRs) SSRs use semiconductor output instead of mechanical
contacts to switch the circuit. The output device is optically-coupled to an LED light source inside the relay. The relay is turned on by energizing this LED, usually with low-voltage DC power.
Microprocessor Based Relays Use microprocessor for switching mechanism.
Commonly used in power system monitoring and protection.
![Page 6: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/6.jpg)
Advantages/Disadvantages Electromagnetic Relays (EMRs)
Simplicity Not expensive Mechanical Wear
Solid-state Relays (SSRs) No Mechanical movements Faster than EMR No sparking between contacts
Microprocessor-based Relay Much higher precision and more reliable and
durable. Improve the reliability and power quality of
electrical power systems before, during and after faults occur.
Capable of both digital and analog I/O. Higher cost
![Page 7: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/7.jpg)
Why a System Needs Protection?
There is no ‘fault free’ system. It is neither practical nor economical to
build a ‘fault free’ system. Electrical system shall tolerate certain
degree of faults. Usually faults are caused by breakdown of
insulation due to various reasons: system aging, lighting, etc.
![Page 8: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/8.jpg)
Electrical Faults
majority are phase-to-ground faults phase-to-phase phase-phase-phase double-phase-to-ground
![Page 9: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/9.jpg)
Advantages for Using Protective Relays
Detect system failures when they occur and isolate the faulted section from the remaining of the system.
Mitigating the effects of failures after they occur. Minimize risk of fire, danger to personal and other high voltage systems.
![Page 10: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/10.jpg)
Protective Devices Comparison
Circuit Breakers V.S. Relays Relays are like human brain; circuit
breakers are like human muscle. Relays ‘make decisions’ based on settings. Relays send signals to circuit breakers.
Based the sending signals circuit breakers will open/close.
![Page 11: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/11.jpg)
Protective Devices Comparison
Fuses V.S. Relays Relays have different settings and can be
set based on protection requirements. Relays can be reset. Fuses only have one specific characteristic
for a individual type. Fuses cannot be reset but replaced if they
blow.
![Page 12: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/12.jpg)
Protection and Relay Schemes
Motor Protection Transformer Protection Generator Protection
![Page 13: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/13.jpg)
Motor Protection
Timed Overload Locked Rotor Single Phase and Phase Unbalance Other
![Page 14: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/14.jpg)
Motor ProtectionOther
Instantaneous Over current Differential Relays
Under voltage Electromagnetic Relays
Ground Fault Differential Relays
![Page 15: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/15.jpg)
Transformer Protection
Gas and Temperature Monitoring Differential and Ground Fault
Protection
![Page 16: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/16.jpg)
Transformer Protection
Gas Monitoring Relays: These relays will sense any amount of gas
inside the transformer. A tiny little amount of gas will cause transformer explosion.
Temperature Monitoring Relays: These relays are used to monitor the
winding temperature of the transformer and prevent overheating.
![Page 17: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/17.jpg)
Transformer ProtectionGround Fault
For a wye connection, ground fault can be detected from the grounded neutral wire.
![Page 18: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/18.jpg)
Transformer ProtectionGround Fault and Differential Relay
![Page 19: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/19.jpg)
Generator Protection
Differential and Ground Fault Protection
Phase Unbalance
![Page 20: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/20.jpg)
Generator ProtectionDifferential and Ground Fault
![Page 21: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/21.jpg)
Generator ProtectionPhase Unbalance
Some Definitions.. Negative Sequence
Voltage example:
![Page 22: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/22.jpg)
Generator ProtectionPhase Unbalance
Some Definitions.. Negative Sequence:
The direction of rotation of a negative sequence is opposite to what is obtained when the positive sequence are applied.
![Page 23: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/23.jpg)
Generator ProtectionPhase Unbalance
Negative Sequence Relay will constantly measure and compare the magnitude and direction of the current.
![Page 24: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/24.jpg)
Conclusion
Relays control output circuits of a much higher power.
Safety is increased Protective relays are essential for
keeping faults in the system isolated and keep equipment from being damaged.
![Page 25: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/25.jpg)
Reference:
1. A.I. Megahed and O.P. Malik, “Sychronous generator internalfault computation and experimental verification,” IEE Proc. Gener.Transm. Distrib., vol. 145,
2. S.H. Horowitz and A.G. Phadke, Power System Relaying. Hertfordshire,U.K.: Research Studies Press Ltd., 1992
3. IEEE Guide for AC Generator Protection, IEEEStandard C37.102-1995
4. E. O. Schweitzer III and J. Roberts, “Distance Relay Element Design,” in 1992 19th Annual Western Protective Relay Conference Proceedings
![Page 26: relay protection](https://reader030.vdocuments.us/reader030/viewer/2022012309/55324f824a7959ae4b8b4572/html5/thumbnails/26.jpg)
Questions
Thank you