Edited by
@
powered by MakerHealth®
Olson Mask – REVISED 4.7.20 & Rose Hedges
Materials Needed
Instructions
Cotton T-shirt Material or Cotton Weave Fabric (~1/2 yard will make 2-3 masks) – WASH material to pre-shrink prior to sewing
All-Purpose Thread
Preferred -- 23” ¼” Elastic or Large Elastic Hair Bands (2)
Material for ties, ties ~ 16” long each
Scissors, Pins, Sharpie marker
Using the patterns, cut one of each shape. You will need six (6) total pieces.
Sew face 1 and face 2 together along side 3.
Sew mouth 1 and mouth 2 together along side 3.
On mouth 1 and mouth 2 sew fold side 5 over 1/4”
and sew down.
Print Pattern at 100% for Large 90% for Medium
Olson Mask - page 2 @
Instructions - continued
On cheek 1 and cheek 2 fold side 6 over 1/4 inch and sew down.
Match cheek 1 and mouth 1 at the dotted line (7). Sew a 1-inch tack at side 1 and side 2 where the two piece overlap.
Repeat Step 6 for cheek 2 and mouth 2.
With the fronts of the fabric facing each other, sew along the entire perimeter of the mask.
Use one of the slits between the mouth and the cheek to turn the mask ride-side out.
Edited by
Olson Mask - page 3 @
Instructions - continued
Add 23” of ¼” Elastic (Preferred - as shown in picture) or hair tie to each side by folding the
fabric on the end of the mask over the tie and
sew down.
Note: If ties are used instead of elastic bands, ties should be approximately 16” each at upper and
lower ends on both sides of mask. See below.
Write M or L on the inside (area where mouth section and Cheek sections overlap)
10
11
M
@ powered by MakerHe al th®
Olson Mask - Face Pattern
4
Face 1
Note – please cut mask patterns ~ ½” to ¾” larger than shown (total width, so ¼” to 3/8” on all sides)
1
3
4
4
2
4
@ powered by MakerHe al th®
1
3
2
Olson Mask - Face Pattern
4
La
rge
3 1
/8 –
3 1
/4 “
M
ed
ium
2 7
/8 –
3”
Face 2
Note – please cut mask patterns ~ ½” to ¾” larger than shown (total
width, so ¼” to 3/8” on all sides)
2
4
3
4
1
4
4
4
@ powered by MakerHe al th®
1
3
2
Mouth 1
Olson Mask - Mouth & Cheek Pattern
Note – please cut mask patterns ~ ½” to ¾” larger than shown (total width, so ¼” to 3/8” on all sides)
Note – please cut mask patterns ~ ½” to ¾” larger than shown (total width, so ¼” to 3/8” on all sides)
@ powered by MakerHe al th®
Olson Mask - Mouth & Cheek Pattern
Mouth 2
Note – please cut mask patterns
~ ½” to ¾” larger than shown (total width, so ¼” to 3/8” on all sides)
Note – please cut mask patterns ~ ½” to ¾” larger than shown (total width, so
¼” to 3/8” on all sides)
6
4
7
4 1
4
4
2
4