John Deere Mobile RTK Quick Reference GuideSetup Mobile-RTK 1 Select Setup tab.
2 Check SF2 fallback (optional).
3 Select Serial Port tab.
4 Set Baud Rate to “19200”.
5 Set output rate with 1 Hz.
6 Check GGA box.
7 Select “M-RTK” softkey (H).
8 Select “RTCM” or “CMR” correction type.
9 ConfigureM-RTKPort.
10 Set Baud Rate to “19200”.
11 Set Parity to “None”.
12 Set Output Rate(s) to “1”.
13 CheckNMEAMessageGGAbox.
14 Set Data Bits to “8”.
15 Set Stop Bits to “1”.
16 Set Modem Type to “Smart Modem” and enter data from cellular and data correction provider.
NOTE:Pressingthe“Read”button forSignalstrengthwilltime-outtheconnection for up to one minute.
StarFire 3000 - Main SN: 109698
Info Setup Activations Serial Port
StarFire 3000 - Main SN: 123067
StarFire 3000 - StarFire Mobile RTK SN: 391512
Rates
Messages
Info Setup ActivationsSerialPort
StarFire
3D TCM
On
Off
CAL
Correction Mode
Hours On After Shutdown
Correction Type
Corrections Age (s) Data received (kb)
0
Connection duration (hr)
0,0Signal
Strength
System Status M-RTK Correction
RTK Port Configuration
System Status - StarFire 3000 Accuracy (%) GPS Signal (%) SF Signal (dB)
100 100 11,5
RTCM
Mount Direction
Fore/Aft (cm)
180
Baud Rate
GGA
RMC
ZDA
GSA
VTG
Output rate (Hz) 1 5 10
19200
1539,8725
M-RTK
M-RTK Port Configuration
Forward
3
1
20 1
1
819200
None
Height (cm)
282
Use SF2 if RTKSignal Lost
Max CorrectionAge (s)
InitializationTime (min)
Serial Settings andNMEA message
Modem and Network
OutputRate (s)
GGA
Baud Rate
Parity
Data Bits
Stop Bits
Connection Age Limits
RTK RS232 Settings
Configure
Configure
Read
NMEA Message
LastCalibration: Machine
Enable OptimizeShading
Default Correction freq
10:59 pm 11:59 pm
Calibrate10:59 pm
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Copyright © 2012 Deere & Company. All Rights Reserved. THIS MATERIAL IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
PFP12900 (07DEC12)
.....................................
.......................
.....................
...................
Mobile-RTKModemDiagnostic Tractor Cab Installation
1 Modem to be installed in the cab on provided support.
2 Modem Antenna.
3 StarFire 3000 Receiver.
The front of the Mobile RTK Modem is equipped with a yellow LED for status output. It indicates the status of the cellular network and the correction data.
UsetheLEDstatustohelpinquickdiagnosingtheMobileRTKmodem.
Yellow LED
3
1
2