Page 1
Hook Key
126
45
32
32 (3
X)
142
UN
LOC
K E
D12.8
3.9
OPTIONAL
Remove locking tab on the Hook if you wish to create a disassemblable joint. This is best done with a sharp utility knife.
1
2 3
4 5
Installation Guide Pro 55 - Metric
Material High Strength Reinforced NylonColour BlackFixing Method 8G Screws (8x) or Glue
Mark center lines, vertical and horizontal, on both substrates. Flush mounting requires no additional preparation. Line the notches in each component (Hook shown here) with the center lines. Mark-Out Template can also be used.
Hold the component in place and fasten to the substrate with 8 x 8G screws. Repeat for matching component. Ensure sufficient screw embedment in substrate.
Prior to assembly, establish whether the joint is to be permanent or disassemblable.
Assembly the joint remembering the Pro 55 only needs to travel 1 pitch for full engagement.
When assembled, the substrates with be separated by the thickness of the engaged Pro 55.
See second page for Rebate and Set-Back mounting options.
Flush Mounting
Striplox Liquidlox can also be used for mounting the Pro 55.
Page 2
47
143
12.5
127
47 47
143
4
8.5
12.8
1 2
Striplox™ and Joinlox® are trademark and patent protected internationally. Installation Guide Pro 55 - Metric V1.2
Part Rebate - each substrate mounting face is rebating as shown. Ensure sufficient screw embedment in substrate.
Setting back the mounting face of either the Hook (as shown) or Key by 12.8mm results in a concelled joint without the need to cut rebates.
Rebate Mounting
Set-Back Mounting
Full Rebate - 1 of the substrate mounting faces is rebating the full depth as shown. Ensure sufficient screw embedment in substrate.
1
BA
A
C
Direction Indic. Load Capacity
A 200 kg
B 106 kg
C 200 kg
• Tested using particle board and fixed with screws.
• Ensure sufficient screw embedment in substrate.
Load Capacity
Installation Aids
Striplox Mark-Out TemplateDeveloped to aid in the installation of the Striplox Pro 55, 90D 98, Mini 60 and 120.
Visit joinlox.com/striplox or call 1800 JOINLOX to find out more about these installation aids.
Striplox LiquidloxInstant adhesive with a 15 second cure time. Liquidlox delivers a strong and reliable connection between Striplox products and most substrates.
126
45
32
32 (3
X)
127
47 47
143
32 (3
X)
32
32 (3
X)
R5 (4X) R5 (4X)32
A
A
B
B
142
UNLO
CKED
12.8
3.9
4mm deepKey to be recessed
SECTION A-A
9mm deep Hook to be recessed
SECTION B-B
Hook Key
Striplox Pro 55Rapid Assembly Systems
Mounting Data Sheet - Metric VersionAll dimension in mm
General Dimensions
Mounting Dimensions
Striplox Pro 55 Mounting Data Sheet - Metric 1.2
Material High Strength Reinforced NylonColour BlackFixing Method 8g Screws or Glue
STRIPLOXTM JOINLOX® ARE TRADEMARK AND PATENT PROTECTED INTERNATIONALLY
*Ensure sufficient screw embedment in substrate.
16
16 16
Locking Tab(Opt.)