Heat Transfer
Nur Istianah-THP-FTP-UB-2016
Unsteady-state heat transfer
Nur Istianah-THP-FTP-UB-2016
Temperature is changing with time, it is a function of both location and time
It was in such as process: food pasteurization, sterilization, refrigeration/chilling/cooling
9 Nur Istianah-THP-FTP-UB-2016
Introduction
• In another words, in unsteady transient heat conduction, temperature is a function of both time and spatial coordinates
By using Fourier’s Equation governs the temperature response of a
body, and Thermal Energy equation (first law of thermodynamics
for closed system), one can fined the thermal conductivity of any
body by recording temperature change of its center with the time.
Rate of heat transfer by conduction from the center of the body out side or in opposite direction can be describe by Fourier’s Law
11
Unsteady state heat transfer
Nur Istianah-THP-FTP-UB-2016
• When the body is a metal semi infinite slab or cylinder or sphere, for one-dimensional case the combination equation is:
Where for slab m=0
for cylinder m=1
for sphere m=2
From thermodynamics definition of the thermal diffusivity
The general equation may be
modified to:
12
Unsteady state heat transfer
Nur Istianah-THP-FTP-UB-2016
Where
Ti Ts
T
Bi<0.1
Bi=1
Bi>>1
This Figure shows Meaning of Biot number
value (the relation between Biot number value
and the temperature gradient of any solid
object).
Convection Ts
T
Conduction Ti Ts
R
Ti Ts T
13
Biot Number
Nur Istianah-THP-FTP-UB-2016
Three cases for unsteady-state heat transfer
• NBi < 0.1 : negligible internal resistance to heat transfer
• 0.1 < NBi < 40 : finite internal and surface resistance to heat transfer
• NBi > 40 : negligible surface resistance to heat transfer
14 Nur Istianah-THP-FTP-UB-2016
• This indicates that the thermal resistance is negligible compared to the convection resistance and Ti Ts and the solid may have a uniform temperature.
• This phenomenon is called (Lumped Thermal Capacity).
• Where in this case the heat transfer by convection from the surface will balance the change of the internal energy of the solid.
At initial conditions
t = 0 T = Ti
the integration of of the above eq.
T -T¥
Ti -T¥
= e-h
rCpRt
1
G
15
Low Biot Number less than 0.1
Nur Istianah-THP-FTP-UB-2016
This equation shows that the solid body
temperature approaches the surrounding
temperature T exponentially, which
means that the solid temperature change
rapidly at the beginning and slowdown
after.
For a big value of (1/) the solid reach
T in very short time (very high
conducting material).
𝑇 − 𝑇∞𝑇𝑖 − 𝑇∞
= 𝑒−𝑡Γ
G =rCpR
hTime constant
Fourier modules (Fo) • If we rearrange the exponent term in the above equation
𝑡
Γ=
ℎ𝑡
𝜌𝐶𝑝𝑅=
ℎ𝑅
𝑘
𝑘
𝜌𝐶𝑝𝑅2𝑡
Fourier number (Fo)
Fo =a
R2t
15 Nur Istianah-THP-FTP-UB-2016
16
Contoh soal [4]
Nur Istianah-THP-FTP-UB-2016
17 Nur Istianah-THP-FTP-UB-2016
18 Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016
Y = ϴ
X = Bi*Ʈ
19
0.1 <NBi < 40
Finite internal and surface resistances to heat transfer
Cp
k
R
tX
TT
TTY
2
01
1
T1 = suhu medium (K) T0 = suhu awal (K) T = suhu akhir (K) = difusivitas termal t = waktu (detik) k = konduktivitas panas (W/m.K) h = koefisien transfer panas (W/m2.K) = densitas (kg/m3) cp = panas spesifik (J/kg.K) x = posisi dari pusat (m) R = dimensi relatif (1/2 ketebalan) (m)
Nur Istianah-THP-FTP-UB-2016
),,( mnXfY
20
Unsteady State (dimensionless)
R
xn
hR
km
Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016
(Ta–T) (Ta–Ti)
NFo = t / D2
1/NBi
Nur Istianah-THP-FTP-UB-2016
(Ta–T) (Ta–Ti)
NFo = t / D2
1/NBi
Nur Istianah-THP-FTP-UB-2016
(Ta–T) (Ta–Ti)
NFo = t / D2
1/NBi
Nur Istianah-THP-FTP-UB-2016
• For calculation of temperature at any position of the object, Gurney-Lurie Chart can be used.
21
Gurney-Lurie Chart
Nur Istianah-THP-FTP-UB-2016
2
1x
tX
t position Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016
Nur Istianah-THP-FTP-UB-2016 24
Contoh soal [5]
Daging berbentuk persegi dengan ketebalan 2.54 cm mempunyai suhu awal 10°C dimasak dalam oven dengan suhu 177°C sehingga suhu pusat mencapai 121°C. Koefisien konveksi diasumsikan konstan sebesar 25.6 W/m2.K. Hitung waktu yang diperlukan! Konduktivitas panas sebesar 0.69 W/m.K dan difusivitas panas sebesar 5.85x10-4 m2/jam.
Cp
k
R
tX
TT
TTY
2
01
1
T1 = suhu medium (K) T0 = suhu awal (K) T = suhu akhir (K) = difusivitas termal t = waktu (detik) k = konduktivitas panas (W/m.K) h = koefisien transfer panas (W/m2.K) = densitas (kg/m3) cp = panas spesifik (J/kg.K) x = posisi dari pusat (m) R = dimensi relatif (1/2 ketebalan) (m)
Nur Istianah-THP-FTP-UB-2016
),,( mnXfY
20
Unsteady State (dimensionless)
R
xn
hR
km
Nur Istianah-THP-FTP-UB-2016 24
Contoh soal [5]
Produk butter dengan ketebalan 92,4 mm yang mempunyai suhu 277,6 K ditempatkan dalam ruangan bersuhu 297,1 K. Bagian samping dan bawah kontainer butter dianggap terisolasi, sedangkan bagian permukaan atas berhubungan dengan udara luar. Koefisien konveksi sebesar 8,52 W/m2. Hitung suhu pada permukaan atas, pada jarak 25,4 mm di bawah permukaan dan pada bagian tengah dari butter setelah 5 jam dibiarkan di udara luar.
k butter 0,197 W/m.K, cp = 2300 J/kg.K, = 998 kg/m3
Nur Istianah-THP-FTP-UB-2016 25
Latihan soal [2]
Nur Istianah-THP-FTP-UB-2016
9.24 cm
x= 4.62 cm
x= 4.62-2.54=2.08cm
Finite objects
26 Nur Istianah-THP-FTP-UB-2016
27
Finite object
Nur Istianah-THP-FTP-UB-2016
Y x = T1 - Tx dengan Xx dan mx
T1 – T0
Y y = T1 - Ty dengan Xy dan my
T1 – T0
Y z = T1 - Tz dengan Xz dan mz
T1 – T0
Y x,y,z = (Yx)(Yy)(Yz ))= T1 – Tx,y,z
T1 – T0
Nur Istianah-THP-FTP-UB-2016
28
Finite object (Two or three dimension)
Nur Istianah-THP-FTP-UB-2016
Kaleng silinder berisi softdrink mempunyai diameter 4,8 cm dan suhu awal 27C. Kaleng ini disterilkan dalam retort dan dikenai uap dengan suhu 177C. Hitung suhu di pusat kaleng selama pemanasan 45 menit jika bagian atas dan bawah kaleng terisolasi. Koefisien transfer panas dari uap sebesar 4540 W/m2.K. Sifat fisik dari softdrink adalah sebagai berikut; k 0,48 W/m.K dan 2,007 x 10-7 m2/s.
29
Contoh soal [6]
Nur Istianah-THP-FTP-UB-2016 30
Contoh soal [6]
Kaleng silinder berisi puree mempunyai diameter 2,68 in dan tinggi 4 in serta suhu 85 F. Kaleng ini disterilkan dalam retort dan dikenai uap dengan suhu 240 F.
Hitung suhu di pusat kaleng selama pemanasan 45 menit.
Koefisien transfer panas dari uap sebesar 4542 W/m2.K. Sifat fisik dari puree adalah sebagai berikut; k 0,830 W/m.K dan 2,007 x 10-7 m2/s.
Nur Istianah-THP-FTP-UB-2016 31
Latihan soal [3]
• Estimate the time when temperature at the geometric center of a 6 cm diameter apple held in 2C water stream reaches 3C. The initial uniform temperature of the apple is 15C. The convective heat transfer coefficient in water surrounding the apple is 50 W/m2C. The properties of the apple are thermal conductivity k = 0.355 W/mC, specific heat Cp = 3.6 kJ/kgC, and density = 820 kg/m3.
32
Latihan soal [4]
Nur Istianah-THP-FTP-UB-2016
• Estimate the temperature at the geometric center of a food product contained in a 303X406 can exposed to boiling water at 100C for 30 min. The product is assumed to heat and cool by conduction. The initial uniform temperature of product is 35C. The properties of the food are thermal conductivity k = 0.34 W/mC, specific heat Cp = 3.5 kJ/kgC, and density = 900 kg/m3. The convective heat transfer coefficient for boiling water is estimated to be 2000 W/m2C.
34
Latihan soal [5]
Nur Istianah-THP-FTP-UB-2016
1. Karkas daging mempunyai nilai 1073 kg/m3, cp 3,48
kJ/kg.K, dan k 0,498 W/m.K. Daging berbentuk lempeng
mempunyai ketebalan 0,203 m dan suhu awal 37.8 C
didinginkan sehingga suhu pusat mencapai 10 C.
Udara dingin bersuhu 1,7 C dan mempunyai nilai h 39,7
W/m2.K digunakan untuk mendinginkan.
Hitung waktu yang diperlukan.
39 Nur Istianah-THP-FTP-UB-2016
TUGAS
2. Daging berbentuk persegi panjang dengan ketebalan 4 cm
dengan suhu awal 8C dimasak dengan menggunakan
oven bersuhu 185C hingga mencapai suhu pusat 121 C.
Koefisien konveksi diasumsikan konstan dengan nilai
sebesar 25,6 W/m2.K. Nilai konduktivitas panas sebesar
0,69 W/m.K dan nilai difusivitas panas () sebesar 5,85 x
10-4 m2/jam.
• Hitung waktu yang diperlukan untuk proses di atas!
40 Nur Istianah-THP-FTP-UB-2016
3. Pipa baja berisi uap air mempunyai diameter luar 95
mm dan nilai k sebesar 45 W/m.K. Pipa ini dilapisi
dengan 75 mm isolator yang mempunyai nilai k 0,043
W/m.K. Dua termokopel ditempatkan pada antarmuka
antara dinding pipa dan isolator serta pada permukaan
luar isolator dan menunjukkan suhu berturut-turut
125C dan 35C.
• Hitung kehilangan panas yang terjadi per meter pipa.
41 Nur Istianah-THP-FTP-UB-2016
THANKS FOR YOUR ATTENTION
The best person is one give something useful always
Nur Istianah-THP-FTP-UB-2016