Download - Flow Distribution, Pressure Drop and Liquid Holdup in a High-Pressure Trickle Bed Reactor
Flow Distribution, Pressure Drop and Liquid Holdup in a High-Pressure Trickle Bed Reactor
Arnaud Denecheau, Pascal Leroy, Muthanna H. Al-Dahhan, Milorad P. DudukovicChemical Reaction Engineering Laboratory
Total
CHEMICAL REACTION ENGINEERING LABORATORY
Objectives Study the flow distribution of both the liquid and the gas at the exit of the column and its evolution with pressure, liquid and gas velocity. Compare these distribution with the one along the bed given by a series of Computed Tomography (CT) scans. Investigate the influence of the pressure, liquid and gas velocity on the pressure drop and liquid holdup. Understand of the effect of the packing is also a goal of this study. Comparison between sock and dense.
Relevant Work» Literature has been studied to find the most relevant models for pressure drop and liquid holdup.» Ergun’s coefficient, used in several models, has been determined each time the bed was repacked thanks to monophasic gas flow experiments.» Two-phase flow experiments with a water/air system were ran at pressures scaling from 1 to 9 barg.» CT scans have been made in different conditions and compare with the liquid holdup measured and the exit repartition of the liquid.
Setup
The collector is separated in 15 sectors of equal area.
Distributor Collector
The distributor covers the whole area of the column.
Methodology The equation of Bansal et al allows to insure the conservation
of a trickle flow along the bed.
where and are correction factors, is the porosity, Lt is the velocity of transition and S1 & S2 have been so defined that they include particle effective diameter, specific surface area, porosity of the bed, characteristic length of nonspherical particles and sphericity.
Each sector of the collector leads to a different separator equipped with a level for the liquid and a flowmeter for the gas.
Weighting the column at all time allows to determine the liquid holdup.
The pressure drop is read on a differential transducer
Results The maldistribution has been investigated at low pressure
where the influence of the liquid and gas velocity has been determined. The maldistribution factor, Mf, will be taken as defined in Marcandelli et al.(1) :
Figure 1. Pilot unit
Results The experimental pressure drop have been compared with the
following models: Holub(2), Al-Dahhan(3), Larachi(4), Ellman(5) and Larkins(6).
The experimental liquid holdup have been compared with the following models: Holub(2), Larachi(4), Larkins(6), Saez & Carbonell(7), Baldi & Specchia(8) and Wammes(9).
AcknowledgementsThis work is supported by Total.
References1. Marcandelli C., Lamine A.S., Bernard J.R. and Wild G. “Liquid Distribution in Trickle-Bed Reactor,” Oil & Gas Science and
Technology. Rev. IFP, 55 (4), 407 (2000)2. Holub, R.A., M.P. Dudukovic, and P.A. Ramachandran, “Pressure Drop, Liquid Holdup, and Flow Regime Transition in Trickle
Flow,” AIChE J., 39 (2), 302 (1993).3. Al-Dahhan, M.H., M.R. Khadilkar, Y. Wu, and M.P. Dudukovic, “Prediction of Pressure Drop and Liquid Holdup in High-
Pressure Trickle-Bed Reactors,” Ind. Eng. Chem. Res., 37, 793 (1998).4. Larachi, F., A. Laurent, N. Midoux, and G. Wild, “Experimental study of a trickle-bed reactor operating at high pressure: two-
phase pressure drop and liquid saturation,” Chem. Eng. Sci., 46 (5/6), 1233 (1991a)5. Ellman, M. J., N. Midoux, A. Laurent, J.C. Charpentier, “ A New, Improved Pressure Drop Correlation for Trickle Bed
Reactors,” Chem. Eng. Sci., 43, 2201 (1988).6. Larkins, R.P., R.R. White, and D.W. Jeffrey, “Two-Phase Concurrent Flow in Packed Beds,” AIChE J., 7, 231 (1961)7. Sáez, A.E., and R.G. Carbonell, “Hydrodynamic Parameters for Gas-Liquid Cocurrent Flow in Packed Beds,” AIChE J., 31 (1),
52 (1985)8. Specchia, V., and G. Baldi, “Pressure Drop and Liquid Holdup for Two Phase Concurrent Flow in Packed Beds,” Chem. Eng.
Sci., 32, 515 (1977)9. Wammes, W.J.A., J. Middelkamp, W.J. Huisman, C.M. deBaas, and K.R.Westerterp, “Hydrodynamics in a Cocurrent Gas-
Liquid Trickle Bed at Elevated Pressures,” AIChE J., 37, 1849 (1991b)
3/44/1
21
2t G73.5
S
SGL
Introduction and motivationsTrickle-bed reactors (TBRs) are multiphase flow reactors in which liquid and gas flow concurrently downward through a packed bed of catalyst. These reactors are operated at high pressure and temperature and are some of the most widely used in petroleum and chemical processes, for instance in hydrodesulphurization of gas oil. The performance of TBRs highly depends on the hydrodynamics and the distribution of the fluids phases inside the packed bed. Indeed, a bad phase distribution throughout the packing can be detrimental for the performance due to the formation of dry zones, liquid channels, hot spots or poor catalyst wetting efficiency. Consequently, petroleum and chemical industries have to make some research efforts on TBRs to improve the global efficiency of their processes and to abide by the new environmental legislations.
35
710
2.5
2
1.5
1
0.000
0.050
0.100
0.150
0.200
0.250
0.300
Mal
dist
ribu
tion fa
ctor
Gas velocity in cm/ s
Liquid Velocity in mm/ s
1F
FF)1N(N
1M0
2N
1n
nf
Figure 2. Maldistribution vs. velocities
0
2000
4000
6000
8000
10000
12000
14000
16000
18000
0 2000 4000 6000 8000 10000 12000 14000
+ 30 %
- 30 %
Figure 3. pressure drop predicted vs. pressure drop experimental
Figure 4. liquid holdup predicted vs. liquid holdup experimental
(9)
(8)
(6)
(4)(2)
(7)
- 20%
+ 20%
0.1
0.15
0.2
0.25
0.3
0.35
0.1 0.12 0.14 0.16 0.18 0.2 0.22 0.24 0.26 0.28 0.3
(2)(3)(4)(4) updated(5) Low interaction(5) High interaction(6)(6) updated