Download - Factory Wiring Harness- GMC Surb- Scosche
In no event shall Scosche be responsible forclaims beyond the replacement value of thedefective product, or in any way liable or re-sponsible for consequential or incidentaldamages.
FACTORY STEREOCONNECTOR
Using the appropriate Scosche "Car StereoConnector" to adapt to your vehicle'sFactory Wiring Harness Connector inconjunction with the "Factory StereoConnector" will eliminate the need to cutany of your factory wires.
©1998 SCOSCHE INDUSTRIES, INC. 9/98
If you have any questions, you may call our tollfree technical help line at: 1-800-621-3695, x3
Helpful Hints:� The wiring colors of the Factory Stereo Connector
may be different from the wiring colors found on yourstereo.
� Refer to the section entitled "Wire Color Codes"found in this instruction to verify all the wirefunctions. Always use a test light and/or voltagemeter to test wire functions first.
WIRING INSTRUCTIONS:1. Using a test light or voltage meter, determine wire
functions for each of the factory stereo wires foundin your vehicle's dash. i.e. Determine which wire is12 volt constant, 12 volt switched, ground, dimmer,etc.
2. Determine which wires are positive and negative foreach speaker in the vehicle.
3. Disconnect the negative battery cable from thebattery to avoid any short circuits.
4. Match and connect the appropriate wires from theFactory Stereo Connector to the appropriate wiresin the dash previously determined in steps one andtwo.
5. Verify that all wires of the Factorty StereoConnector are connected to the proper wires inyour vehicles dash, and that all connections aresecure.
6. Tape all unused wires to prevent short circuiting.7. Reconnect the negative battery cable to the battery.8. Insert the Stereo Connector into the stereo.9. Check all functions including the fader and balance.
Refer to your stereo owners manual if necessary.
FACTORY HARNESS
Scosche GM02 Wire ConnectorRecommended
GMC1989-UPJIMMY
1988-UPPICKUP FULL-SIZE
1989-UPPICKUPCREWCABDOOLEY
1992-UPS-15 JIMMY
1992-UPS-15 PICKUPSONOMA
1990-UPSAFARI
1989-UPSUBURBAN
1988-UPVAN
1992-UPYUKON BLAZER
OLDSMOBILE1992-UPACHIEVA
1989-UPCUTLASSSUPREME
1987-UPEIGHTY-EIGHTROYALE
1988-UPNINETY-EIGHT
1990-UPSILHOUETTE
1990-UPTORONADO/TROFEO
1988-UPTOURINGSEDAN
1988-UPVILLAGER
PONTIAC1992-UPBONNEVILLE
1990-UPFIREBIRD
1992-UPGRAND AM
1988-UPGRAND PRIX
1990-UPTRANS SPORT
SATURN1991-UPSL/2
1991-UPSC/2 COUPE
1993-UPSW/2 WAGON
BUICK
1991-UPLE SABRE
1991-UPPARK AVEUE
1989-UPREATTA
1988-UPREGAL
1990-UPRIVIERA
1991-UPROADMASTER
1992-UPSKYLARK
CADILLAC1987-93 ALLANTE
1992-UPDE VILLE
1992-UPELDORADO
1992-UPFLEETWOODBROUGHAM
1992-UPSEVILLE
CHEVROLET1990-UPASTRO
1988-UPBERETTA
1989-UPBLAZER
1990-UPCAMARO/Z28
1990-UPCAPRICE/CLASSIC
1991-UPCAVALIER
1988-UPCORSICA
1990-UPCORVETTE
1990-UPLUMINA
1990-UPLUMINA APV
1988-UPPICKUP FULL-SIZE
1989-UPPICKUPCREWCABDOOLEY
1992-UPS-10 BLAZER
1992-Up S-10 PICKUP
1989-Up SUBURBAN
1988-UPVAN
14
4 PLUG WIRE
10 PLUG WIRE
121 1
1098765
1234
13
WIRE COLOR CODES:Factroy Color Codes are Not Avalible At This TimePlease Refer To the Pin Location Below.
10 WIRE PLUGPin #1. = Left Front Negative (LF-).2. = Left Front Positive (LF+).3. = Right Front Negative (RF-).4. = Right Front Positive (RF+).5. = Chassis Ground (12V-).6. = Not Used.7. = Illumination/Dimmer.8. = Power Antenna.9. = 12 Volt Ignition/Switched (12V+).
10. = 12 Volt Battery/Constant (12V+).4 WIRE PLUGPin #11. = Right Rear Negative (RR-).12. = Right Rear Positive (RR+).13. = Left Rear Negative (LR-).14. = Left Rear Positive (LR+).
Scosche GM02 Wire ConnectorRecommended