4.CERAMIC HEAD WORK
1. AERATOR
2. FILTER
5. BOLT
6. BOLT
3.NUT
SPECIFICATIONS
OPERATING CONDITIONS
S06219S
TROUBLESHOOTING
"EGO" THERMOSTAT BATH & SHOWER SET TX449SE
TX449SEN"EGO" Thermostat Bath & Shower Set
INSTALLATION MOUNT CONNECTORS PARALLEL WITH THE
WALL
1
3
5
A0905
OPTIONAL SHOWER
TYPE SHOWERD1205QMFT1
A0905
Cover
Spout
Filter
Body
CHECKPOINT
Flow rate unsatisfactory 1, 2 Remove and cleanWater leaks around the handle Tighten
PROBLEM SOLUTION
Handle is loose 5, 6 Tighten3, 4
Flexible Hosew/ Packing
Screw
Hanger
Hand Shower
150±20
150
Hot Water
Supply
Cold Water Supply
Leg
2
4
Adjust the number 40º on the handle with mark line in the body, then install the handle
If get the water temperature at 40ºC, release the handle. Make sure the spindle not rotated.
640
Mark LineHandle
Spindle
Bolt
Handle
40oC
Safety Knob
Open full the stop valve and check the water temperature 40ºC. When water temperature not 40ºC , set the water temperature until get 40ºC then follow step 5 and 6.
2 X Ø8 Holes
TX449SEV1N"EGO" Thermostat Bath & Shower Mixer w/o Hand Shower Set
MAINTENANCEAlways wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap.
TX449SEV2Z"EGOII " Thermostat Bath & Shower Set
_
MARK
Sleeve Anchor
17142°
Ø8
20
40
5547
Ø50
215.5 0-7
PJ ½150±20
228 0 -7
D1205QMFT1
Cap
ALIGN WITH MARK
OPEN
O-Ring
R4
BoltWasher
Cap
Washer
ATTENTION1. Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended.2. Press safety knob turn left to increase temperature over 40oC.3. Please don't open the thermostat cartridge, because it cause to unstabilize temperature in this product.4. Flow Regulator should not be remove because it could damage the system
1. Water supply pressure : 0.05 ~ 0.75 MPa.Hot water supply temperature shall be higher by 10oC. at least, than desired temperature of mixed water. (Recommendation: Hot water supply temperature =60oC)Hot water supply pressure shall be the same or lower than cold water supply .Ensure that water supply is clean (No Sand, Dirt, Etc.).
2.
3.
4.
Flow Regulator Inside (Don’t remove)
Rain Spray Button
Massage Spray Button