Download - BTEL Radio Transmission ATP Form v1.6.xls
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
1/19
Form No.: 0219/ATP/BTEL-TX Plan/02/2009
Project :
PO Ref No. : Date :
Link :
WO Ref No. : Date :
On this day,(day) , (month) (date), (year), the undersigned on behalf of the following parties:
I. (BTEL Project Manager),PT.Bakrie Telecom, hereinafter referred as THE FIRST PARTY.
II. (Vendor represent Name), (Vendor title represent Name), (Vendor Company Name), hereinafter referred as THE SECOND PARTY.
Both parties agreed and state as follow:
1. Whereas in relation with the obligation of THE SECOND PARTY to supply and installation Transmission Link Systemincluding technical, schedule and material requirements thereof as referred to in the Purchase Order or Agreement.
2. The both parties tested and commissioned the mentioned above of supply and install the Transmission Link Systemas stated at attached documents as follows :
2.1 Commissioning Test Form,2.2 Site inventory data2.3 As-built deliverables2.4 Functional Test & Installation Quality Inspection Result
These certificates are made in two-fold, having similar contents and equal legal power for proper perusal.
THE SECOND PARTY THE FIRST PARTY (Vendor Company Name) PT. Bakrie Telecom, Tbk.
____________________Title Title
BTEL Radio Link ATP Certificate Form Version 1.4
( )
TRANSMISSION LINK
ACCEPTANCE TEST CERTIFICATENo._______________(Vendor Letter/Agreement system No.)
This document is part of Hand over system
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
2/19
This Document is part of handover system Commisioning Test Document
Site InfoRegional ID
Site Name
Site Address
City
Province/State
Postal Code
Latitude (in degrees decimal format)
Longitude (in degrees decimal format)
Link InformationLink Name
Link Format (PDH/ SDH/ IP etc)
LOS distance (km)
Radio TypeVendor
Capacity (4E1/ 16E1/ 63E1/ STM-1)
Protection Type (1+0/ 2+0/ 1+1HSB)
Installed Date
Ready For Service Date
Link parameters WO / Standard Value Measured ValueOK / Not OK /
NARemark
Near End / Radio-1
Rx Level (- dBm) Rx Level(ET) + 4dB attach result in capture sheet
Tx Level (+ dBm) as state in ET/WO attach result in capture sheet
Interference Level (- dBm) < -90dBm attach result in capture sheet
Tx frequency, Channel No. (MHz)Rx frequency, Channel No. (MHz)
ODU frequency sub band
Center frequency (GHz) as state in ET/WO
BER test (8hr for PDH, 24hr for SDH) PDH
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
3/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
4/19
SITE INVENTORY DATA
SITE INFOSite Name
Antenna - 1 Antenna - 2 Antenna - 1
Diameter (m)
Type
Part Number
Manufacturer
Gain (dB)
Freq (GHz)
Antenna height (m AGL)
Azimuth (o degres)
Polarization (V/H)
Type
Part Number
Manufacturer
Serial Number
Firmware Version
Type
Part Number
Manufacturer
Length (m)
Remark
Indoor Unit - 1
Module#1
Module#2
Module#3
(list all of modules installed)
Indoor Unit - 2
Module#1
Module#2
Module#3(list all of modules installed)
Indoor Unit - 1
Module#1
Module#2
Module#3
OUTDOOR UNIT Description
NEAR END (Site A) FAR ENANTENNA
Remark
INDOOR UNITFAR END (SITE B) Slot Position Board Type
FAR END (Site B)FEEDERS/CABLES NEAR END (Site A)
INDOOR UNITNEAR END (SITE A) Slot Position Board Type Part Number
Part Number
NEAR END (Site A) FAR EN
Site Satu Sit
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
5/19
(list all of modules installed)
Indoor Unit - 2
Module#1
Module#2
Module#3
(list all of modules installed)
MUX Information NEAR END (Site A) FAR END (Site B)
Mux Type
Manufacturer
SDH (STM-1) Capacity
Trunk (E1) Capacity
Impedance (ohm)
MUX
Module#1
Module#2
Module#3
(list all of modules installed)
MUX
Module#1
Module#2
Module#3
(list all of modules installed)
THE SECOND PARTY
(Vendor Company Name)
____________________
Title
MUX ModulesFAR END (SITE B) Slot Position Board Type Part Number
MUX ModulesNEAR END (SITE A) Slot Position Board Type Part Number
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
6/19
Antenna - 2
D (Site B)
Serial Number Firmware Version
Remark
D (Site B)
Dua
Remark
Serial Number Firmware Version
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
7/19
THE FIRST PARTY
PT. Bakrie Telecom, Tbk.
( )
Title
Remark
Serial Number Firmware Version Remark
Serial Number Firmware Version
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
8/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
9/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
10/19
Location-
Site Type
Location-
Site Type
Location-
Site Type Regional
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
11/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
12/19
Country
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
13/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
14/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
15/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
16/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
17/19
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
18/19
AS BUILT DELIVERABLESContent :a. Link Configuration
b. As Built Installation drawing & wiring (NEAR END and FAR END site)
b.1 Antenna & Tower Layout
b.2 Equipment room layoutb.3 Rack/Frame layout
b.4 Radio & Mux Installation (wiring & board)
b.5 DDF wiring and connection (see format below)
b.6 Image/photo documentation
c. IP Network Element (NE) Configuration
c.1 IP Address assignment (see format below)
c.2 NMS network & node configuration
b.5 DDF wiring and connection
Equipment Board TypeSlot
Number
Port
Number
DDF Index(Number of DDF Group)
Block(DDF Frame Number)
Column Row Port
c. IP Address assignmentNE Configuration Local side
Site Identifier(NE ID)
Local IP address
Subnet Mask IP
Address
Gateway IP Address
Remark
THE SECOND PARTY THE FIRST PARTY
(Vendor Company Name) PT. Bakrie Telecom, Tbk.
DDFEquipment (IDU or MUX)
ConnectionType
Remark
Remote Side
-
8/11/2019 BTEL Radio Transmission ATP Form v1.6.xls
19/19
____________________ ( )
Title Title