Atomistic Wulff construction and the shape of nanoparticles
of noble metals
Ioannis N. Remediakis
Department of Materials Science and Technology, University of Crete, Greece
International Conference on Applied MathematicsACMAC, Heraklion, September 16 - 20, 2013
http://theory.materials.uoc.gr 2
Outline
● Equilibrium shape: 20th century and the nano-era (1995-).
● Equilibrium shape from first principles (2005-).
● Au nanoparticles from first principles and the atomistic Wulff construction method.
● Ag nanoparticles as catalysts for hydrogenation of triple bonds.
http://theory.materials.uoc.gr 3
Equilibrium shape (1878)
G = Gb u l k + Σ γh k l Ah k l = min.
Surface tension γ = (Surface energy) / (area)(Surface energy) = (Energy )- (Energy of bulk)
http://theory.materials.uoc.gr 4
Wulff's theorem(Wulff 1901) Minimum energy polyhedron:
dh k l / γh k l = constant
Low-energy -> large area -> closer to center.
First Proof: M. Von Laue (1943).
Short proof by R. F. Strickland-Constable (1968):
G=ΣγhklAhkl minimized for constant V=Σ(1/3)dhklAhkl :
δ(G-λV)=0 => Σ(γhkl-cdhkl)δAhkl=0 => γhkl=cdhkl (QED).
http://theory.materials.uoc.gr 5
An example of Wulff construction dh k l/γh k l = constant (d=distance from center).
Orthorhombic material (e.g aragonite CaCO3) with
γ100=γ110=γ=0.5γ010 << γ001 << γhkl.
Crystal habit: elongated rods (Cross section below).
http://theory.materials.uoc.gr 6
Properties of equilibrium shape
● The shape depends on ratios between surface tensions. ● (hkl) planes with high surface tension (usually high-indexed ones) are less likely to appear in the equilibrium shape.● Being steeper, high-index faces are usually hidden behind low-index ones, even if γhkl is not very high.
● The extra energy associated with the formation of edges be-tween two surfaces is neglected.● The Wulff polyhedron has the same point group (or its super-group) as the crystal structure of the material.
http://theory.materials.uoc.gr 7
Examples of Oh polyhedra (fcc metals)● Symmetry is necessary (but not sufficient) condition that the system has reached equilibrium. A non symmet-ric (large) particle is most likely out of equilibrium.
● Face-Centered Cubic (FCC) is the most symmetric close-packed structure.
● Oh = {E, 8C3, 6C2, 6C4, 3C42,
I, 6S4, 8S6, 3σh, 6σd}
http://theory.materials.uoc.gr 8
Equilibrium shapes in nature
G = Gb u l k + Σ γh k l Ah k l
Equilibrium shape: minerals (billions of years to equilibrate) or nanoparticles (small size).
www.mindat.org Turner et al., Adv. Func. Mater. 2009
http://theory.materials.uoc.gr 9
Wulff's theorem and nanoparticles
http://theory.materials.uoc.gr 10
Wulff's theorem and nanoparticles
http://theory.materials.uoc.gr 11
Wulff's theorem and nanoparticles
P. L. Hansen, J. B. Wagner, S. Helveg, J. R. Rostrup-Nielsen, B. S. Clausen, H. Topsøe, Atom-Resolved Imaging of Dynamic Shape Changes in Supported
Copper Nanocrystals, Science 295 2053 (2002).
http://theory.materials.uoc.gr 12
Surface tesion of Ru(hkl) from DFT
http://theory.materials.uoc.gr 13
Virtual catalyst for NH3 synthesis
K. Honkala, A. Hellman, I. N. Remediakis, A. Logadottir,A. Carlsson, S. Dahl, C.H. Christensen and J. K. Nørskov,
Science, 307 558 (2005);Surf. Sci., 600, 4264 (2006);Surf. Sci., 603, 1731 (2009).
http://theory.materials.uoc.gr 14
Equilibrium shape of Au nanoparticles from first principles
● Using Density Functional Theory, we calculate the surface tension of different Au surfaces.
● Using Wulff construction, we find nanoparticles with minimum en-ergy.
● Take into account interactions of nanoparticle with its environment.
● Converge the method with respect to the number of orientations.
http://theory.materials.uoc.gr 15
First-principles atomistic calculations
Input: Coordinates of the nuclei plus numerical parameters.
Output: equilibrium structure for given external fields, and/or response functions (usually).
Advantage: Understanding and design of materials at their ultimate level: elecrtrons and nuclei (or ions).
Density-functional Theory (DFT): Hψ=Εψ; H=K+Ve-ion+Ve-e+Vx-c : Ve-ion:pseudopotential; Ve-e: mean-field electron-electron; Vxc: many body plus self-interaction correction.
Here: DACAPO, GPAW and ASE (GPL'd open source software) http://www.camd.dtu.dk/Software
http://theory.materials.uoc.gr 16
Modeling Au surfaces with DFT● Slab model.
● Parameters chosen for convergence of surface tension within 0.01 J/m2.
● Calculate total energy of slab and bulk Au.
● Eslab = N Ebulk+2Aγ
http://theory.materials.uoc.gr 17
γhkl ~ Nhkl ; Νhkl=2h+k or 4h+2k.
(Mackenzie et al., J. Phys. Chem. Solids (1962))
a: MAEAM, Wen & Zhang, (2007);
b: LMTO+Mckenzie, Galanakis et al. (2002).
Surface tensions, equilib. shapes
http://theory.materials.uoc.gr 18
Equilibrium shapes
● Predicted nanoparticles match observations even at small sizes.
http://theory.materials.uoc.gr 19
Environment-dependent shape
● In a reactive environment, Nads/A molecules may
attach to the solid surface and form bonds of energy Eads
each, lowering thus the surface tension (γ) to (γint).
γint=γ+NadsEads/A
● Large difference in γ (and nanoparticle shape) only for strong bindind AND high concentration.
http://theory.materials.uoc.gr 20
CO Adsorption on Au
G. Mpourmpakis, A. N. Andriotis, D. G. Vlachos, Nano Lett. 10, 1041 (2010) ; S. R. Bahn, N. Lopez, J. K. Nørskov, and K. W. Jacobsen, Phys. Rev. B 66, 081405 (2002)
The first calculation of CO on every Au(hkl).
Barmparis and INR, PRB 2012.
http://theory.materials.uoc.gr 21
Au nanoparticles in CO gas
TEM by K. Ueda, T. Kawasaki, H. Hasegawa, T. Tanji and M. Ichihashi, Surf. Interf. Anal. 40, 1725 (2008).
γint=γ+θEads/Aat
http://theory.materials.uoc.gr 22
Thiol adsorption on Au
http://theory.materials.uoc.gr 23
Thiol-protected Au nanoparticles
Barmparis, Honkala, Remediakis, J. Chem. Phys. 2013
http://theory.materials.uoc.gr 24
Adsorption increases reactivity.
Barmparis, Honkala, Remediakis, J. Chem. Phys. 2013
http://theory.materials.uoc.gr 25
Application: active sites for catalysis.
http://theory.materials.uoc.gr 26
Warm-up: CO + ½O2 → CO2
● Rate: r=k [CO] [O2]½ – k' [CO2]
● k=k0 exp(-Ea/RT)
● Chemical equilibrium: [CO2] = K [CO] [O2]
½
● K = k / k' = K0 exp(-ΔH/RT)
● [CO] = NCO/N = PCO/P = pCO
● Adsorbed: [CO*] = NCO*/N ≡ θCO
Image from wikipedia
http://theory.materials.uoc.gr 27
r=kKCOKO2½pCO(1-pCO)½/(1+KCOpCO+KO2
½(1-pCO)½)
http://theory.materials.uoc.gr 28
Turnover frequency (TOF)
TOF = (mols of product per second per gram of catalyst) = (reaction rate per site)×(sites per gram of catalyst) = (reaction rate per site)×(sites per gram of metal)×(wt % metal in catalyst).
Reaction rate: from experiments on single-crystal surfaces or DFT-TST simulations.
Metal content of catalyst from analytical chemistry.
Site density: usually not calculated, but some times compared to the number of atoms per unit mass (equals Vi / ρ ).
http://theory.materials.uoc.gr 29
Density of surface sites: octahedra
R. Van Hardeveld, F. Hartog, The statistics of surface atoms and surface sites on metal crystals, Surf, Sci., 15, 189-230 (1969).
n=N surf /N A
M=
AAat
/N A
ρV=
1Aat N A ρ
AV
http://theory.materials.uoc.gr 30
Active sites
Logadottir A, Rod TH, Norskov JK, Hammer B, Dahl S, Jacobsen CJH (2001)
J Catal 197:229
http://theory.materials.uoc.gr 31
Hyfrogenation of propyne
http://theory.materials.uoc.gr 32
Reaction order (1) dissociation mechanism
(2) association mechanism
http://theory.materials.uoc.gr 33
Selectivity
The reaction stops at the first hydro-genation:
CH3--̶C≡CH → CH3--̶CH=CH2
CH3--̶CH=CH2 ↛ CH3--̶CH2--̶CH3
From DFT calculations:
Propene desorption: Ea=0.14 eV; propene hydrogenation: Ea=1.01 eV.
http://theory.materials.uoc.gr 34
A maximum at 4.5 nm particles
http://theory.materials.uoc.gr 35
Equilibrium shape of Ag particles
http://theory.materials.uoc.gr 36
B5 sites are the active sites
http://theory.materials.uoc.gr 37
B5 sites exists mostly above 4.3 nm
http://theory.materials.uoc.gr 38
Wulff construction gives the key
Vile et al., ChemCatChem 2013 (in press)
http://theory.materials.uoc.gr 39
Conclusions
Multi-scale model based on quantum-mechanical calculations and the Wulff construction yields accurate equilibrium shapes for metal nanoparticles.
Nanoparticles in weakly interactive environments have similar shapes.
Nanoparticles increase their sphericity and reactivity upon ex-posure to reactive environment.
Atomistic Wulff construction can be used for the accurate counting of active sites in realistic catalysts.
http://theory.materials.uoc.gr 40
● C. Bittencourt, (U. Mons, Belgium)
● G. Kopidakis.
● G. Barmparis.
● N. Lopez (Institute of Chemical Research of Catalonia).
● K. Honkala (Jyväskylä University, Finland).
Acknowledgements
● Gianvito Vilé, Javier Pérez-Ramírez (ETH Zurich)
● C. Bittencourt, (U. Mons, Belgium)
● G. Kopidakis.
● G. Barmparis.
● N. Lopez (Institute of Chemical Research of Catalonia).
● K. Honkala (Jyväskylä University, Finland).
● C. Bittencourt, (U. Mons, Belgium)
● G. Kopidakis.
● G. Barmparis.
● N. Lopez (Institute of Chemical Research of Catalonia).
● K. Honkala (Jyväskylä University, Finland).