FlangeFully modular to IEC and compact integratedmotor.NEMA C flange.

Premium, hightemperatureNitrile® output seals

Single-piece aluminum alloy housingIs vacuum impregnated (MIL-STD 276) for protection and sealing.No secondary finish required but readilyaccepts paint. Combines light weight withhigh tensile strength. Precision machinedfor alignment of bearings and gearing.

Single piece alloy steelinput shaft and worm shaft.High helix angle worm iscase-hardened (Rc 58-60),ground, teeth are profiled and radiused, for noise reduction and enhanced efficiency.

Oversized bearingsSupport positively-retained,high speed shaft for higher shock load capacity - ideal for frequent starting and reversing application.Premium, Nitrile® hightemperature seals each end.

Impregnated andmachined bearing capsWith exterior machinedsurfaces enable a varietyof mounting accessories.Extra-deep thread engagement provided for greater support strength. Zinc plated hardware.

Bronze alloy worm gears.Is centrifugally cast onto aniron hub for maximumstrenght and superior life.

Oversize bearingFor radial load capability and maximum hollow output shaft diameter.

Anticorrosive worm gearboxes basic features

StandardSTAINLESS STEELhollow output shaft

StandardSTAINLESS STEELsingle output shaft

On request

- Special paint

- Viton output seal

- Stainless steel fasteners

vent free

oil freeVent Free Design.No breather or vents to leak! Factory lubricated for life with synthetic, semi-fluid gear lubricant with an operating range of -15ºC to 130ºC.

StandardZINC PLATED

fasteners

Worm boxes type 030 ÷ 110gear

Factory 19 / 5 Lyn Parade PRESTONS NSW 2170

PH: 02 9607 4100 FAX: 02 9607 4200

www.tonson-motor.com.au

Stallion Stainless Steel Electric Motors