DATASHEET - DP2P-PRO

Transparent Wireless Point -to- Point Bridge Professional Series

The Dolphin Wireless professional series DP2P-PRO wireless bridge provides 5GHz carrier class point-to-point connectivity between fi xed sites.

Featuring an IP67 rated integrated enclosure with an 18dBi dual polarized antenna, 802.11a/n 2x2 MiMo wireless, and a 10/100/1000 Gigabit Ethernet port with Auto-MDI/X, the DP2P18dBi provides reliable network links for backhaul applications such as connectivity to remote sites, VOIP, CCTV and access control. This offers a cost effective alternative to fi xed line services such as underground cabling, catenary wires, or leased lines. Designed to provide a permanent fi xed solution or temporary connectivity between sites, the speed and ease of installation also makes these units ideal for quick deployment in the fi eld.

Supplied as a complete kit including mounting brackets the DP2P18dBi comes pre-confi gured as a transparent bridge allowing a link to be established with minimal setup time. An easy to use web interface provides access to a comprehensive range of confi guration options and management tools.

• Up to 110Mbps Full Duplex

• Up to 220Mbps Simplex

• Range up to 5km, LOS/Near LOS*

• Power over Ethernet

• Quick and easy deployment with audio assisted alignment

The Dolphin Wireless professional series

Horizontal plane

Vertical plane

Radio Specifi cation• Wireless 5GHz 802.11 a/n High power dual chain MIMO (up to 30dBm)* w/ built-in 10Kv ESD protection on each RF chain. 5.4 - 5.85GHz

• Max transmit power* 30dBm

• TX power 802.11a: 27dBm @ 6Mbps to 23dBm @54 Mbps 802.11n 27dBm @ MCS0/8 to 22dBm @ MCS7/15

• RX sensitivity 802.11a: -92dBm @ 6Mbps to -76dBm @ 54Mbps 802.11n: -92dBm @ MCS0 20MHz to – 73dBm @ MCS7 40MHz

• Modulations OFDM, BPSK, QPSK, 16 QAM, 64QAM, DSSS, DBPSK, DQPSK, CCK

Antenna Specifi cation• Frequency 5.4 – 5.85 GHz

• Gain 2 x 18dBi

• Polarization Dual Horizontal and Vertical

• Beamwidth degree horizontal 38

• Beamwidth degree vertical 15

• VSWR < 2

• Impedance 50 ohm

• Front to back ratio 35db

• Lightning protection DC ground

General Specifi cation

• Ethernet 1 x Gigabit Ethernet with auto-MDI/X

• Power options 18V Gigabit P-POE on Ethernet Port (Non 802.3af)

• CPU Atheros AR9342 600MHz network processor

• Memory 32MB DDR on-board memory

• Data storage On-board NAND memory chip

• Software specifi cation • IEEE 802.11 a/n wireless protocol • Nstreme & Nstreme2 (NV2) protocols with encryption • Client polling • RTS/CTS • Wireless Distribution System (WDS) • Access control list • WMM • MME wireless routing protocol

• VPN • Ipsec – Tunnel and transport mode, certifi cate or PSK, AH and ESP security protocols • Point-to-point tunnelling (OpenVPN,PPTP,PPPoE,L2TP,IPIP,EoIP) • Advanced PPP features(MLPPP,BCP) • MPLS based VPN’s • 6 to 4 tunnel support(IPv6 over IPv4 networks) • VLAN – IEEE 802.1q Virtual LAN support, MPLS

• Setup & confi guration tools • Reset beeper • Audio alignment • Ping • Bandwidth test • Torch • Traffi c Generator, Traffi c Monitor • Web-based confi guration interface

• Dimensions (excluding brackets) 270mm x 270mm x 75mm (10,6x10,6x2,9)

• UV Protected Yes• Min temperature -35 °c• Max temperature 60 °c

• Weight (excluding mounting hardware) 350g

* Specifi cation refers to hardware capability. Output power is determined by the country of operation selected within the confi guration utility. UK legislation permits a maximum of 4 Watts EIRP and therefore units supplied to UK will be pre-confi gured accordingly.

*NLOS is site specifi c and a site survey would be recommended. Obstructions will cause a drop in throughput even when a link can still be established