dependence of ntm stabilization on location of current drive relative to island

1APS DPP 2006October 31 2006

Dependence of NTM Stabilization on Location of Current Drive

Relative to IslandJ. Woodby1

L. Luo1, E. Schuster1

F. D. Halpern2 ,G. Bateman2, A. H. Kritz2

1Department of Mechanical Engineering2Department of Physics

Lehigh University, Bethlehem, PA 18015

48th Annual Meeting of the Division of Plasma PhysicsAmerican Physical Society

30 October – 3 November 2006Philadelphia, Pennsylvania


AbstractHigh plasma pressure can cause ideally nested magnetic flux surfaces to tear and reconnect, leading to the formation of magnetic islands. The neoclassical tearing mode (NTM) instability drives the islands to grow to their saturated widths, at which they can persist stably in the plasma. The presence of magnetic islands leads to a local flattening of the pressure and current profiles, which is undesirable as it degrades plasma confinement. One common method of replacing lost current within islands is direct current injection via electron cyclotron current drive (ECCD). The greatest effect of current drive on the island width is achieved when current is driven near the island center. In preparation for feedback stabilization of NTMs, the effect of off-center current drive on the saturated magnetic island widths is considered here. The off-center drive is modeled mathematically by a parabolic current density peak (the center of which need not coincide with the island center), which is then transformed into Hamada coordinates. The results are implemented in the ISLAND module, which is used in BALDUR.*

* JP1.00142


Objectives• It has been shown that increasing current within magnetic islands

shrinks the island• Localized current drive (e.g. ECCD) can be used to inject current

into islands, with the strongest shrinking effect when current is injected into island center

• Difficulty lies in determining the position of the island flux surface in real time

• Past work has lead to an expression in the ISLAND module which allows for centered current drive only

• This work seeks to model current drive with the possibility of shifting the drive center off the island

• This is in preparation for feedback stabilization, for which it is necessary to consider off-center current drive


References

• ISLAND module from NTCC module library: http://w3.pppl.gov/ntcc• Background, finding saturated magnetic island widths, ISLAND:

- F. Halpern, Physics of Plasmas 13 (2006) 062510- C.N. Nguyen and G. Bateman, Physics of Plasmas 11 (7) (2004)- G. Bateman and R.N. Morris, Phys. Fluids 29 (3) (1986)

• Similar work expressing current drive in Hamada coordinates:- G. Giruzzi et al., Nuclear Fusion 39 (1999) 107-125- C. Hegna and J. Callen, Physics of Plasmas 4 (1997) 2940

• Computing elliptic integrals: www.netlib.org• JP1.00142 “Adaptive Extremum Seeking Control of Current Drive for NTM Stabilization”


• Using Hamada-like coordinate system

(V is any quantity which is constant over a flux surface, such as volume, are anglelike variables in the poloidal and toroidal directions, respectively)

• Get set of coupled ODEs which describe change in background current and pressure profiles due to presence of island• Implemented in ISLAND module (used in BALDUR) which computes saturated magnetic island widths

• NTM=neoclassical tearing mode, magnetic “islands” result from tearing and

reconnection of ideally nested magnetic flux surfaces • Starting from force-balance eqs

Background


(1)

(2)

where J is the Jacobian, the elements B0 and J0 are the background magnetic field and current density, and the perturbations on these, B1 and J1, are expressed in terms of both contravariant and covariant components in Hamada coordinates

ODEs to find saturated magnetic island widths


Previous work: Toroidal current density is proportional to

Current density is flattened by magnetic island, centered current peaking is controlled by

Current profile for centered peak

= island halfwidth


• The ISLAND module uses , = averaged current

• To find integrate (at fixed V) over the angle

• Result without current drive:

where is the incomplete elliptic integral of the first kind

Derivative of averaged current


Preliminary code modification• Implemented exact elliptic integral in term in ISLAND to replace

analytic approximations

• Result: Similar saturated island widths

Factor proportional to current drive

u

= radial coordinate centered on island


with different portions of the current drive both inside and outside the island, depending on the current drive shape

• Generalize current drive term to include drive offset from island center

Modified current profile


Assume that the current drive has the following form

Off-center current drive


• Current applied in u-coordinates gets spread over magnetic flux surfaces, given by

• Relation between u-coordinates and flux surfaces (Taylor expansion of near mode-rational surfaces):

Finding average driven current


• Current applied in u-coordinates onto a differential area dA gets spread over flux surface it hits, over dS, the corresponding differential area in flux surface coordinates

• Or, inserting the Taylor expansion for

• Now integrate over and to get the averaged current drive density

Derivation of average driven current - 1


• The average current density is given by

• Note that the average must be taken separately within the island

( is the separatrix, or island edge) and outside, since the area ratio dA/dS will vary• Problem: even if dA/dS is assumed to be constant, this integral cannot be done

analytically

Derivation of average driven current - 2


1: Assume all the current is driven near the widest part of the island, at

2: Assume that dA/dS is constant and the same constant both inside and outside the island

Simplifying assumptions


• Result for averaged current drive (setting dA/dS = 1):

• Taking the derivative

where is the complete elliptic integral of the first kind

and

Result of current drive derivation

where is the complete elliptic integral of the second kind

and


• In this derivation, since the integral was taken separately for positive and negative u, the result is not symmetric within the island, even though flux surfaces form closed loops there.

• In effect, we assumed that any current applied in positive u will get spread over the flux surfaces it hits in the positive u region only

• For implementation in ISLAND, we have symmetrized the result by assuming that when current is driven at a positive offset (+a), an equivalent current is driven on the other side, at (-a). We then normalized the result so that increasing the offset would not result in a larger total current drive.

Additional assumption - Symmetry


Symmetrized current drive density “Typical” case

Results not normalized


Symmetrized current drive density Centered drive



Symmetrized current drive density Increased power



Symmetrized current drive densityNarrow drive



Symmetrized current drive densityCompletely off island



Summary• Implemented exact elliptic integrals in ISLAND to replace

analytic approximations; similar saturated island widths• After making several simplifying assumptions, found analytical

expression for averaged current drive in Hamada coordinates, which was then symmetrized, normalized and implemented in ISLAND

Future work• Generalize result to include current driven at all toroidal angles

simultaneously, not only near island center• Symmetrize results only within island, where flux surfaces form

closed loops• Include effect of dA/dS, which is not constant

dependence of ntm stabilization on location of current drive relative to island

Documents