creo interview qa

Upload: viswatej-choudary

Post on 17-Feb-2018

215 views

Category:

Documents


0 download

TRANSCRIPT

  • 7/23/2019 Creo interview QA

    1/2

    1) What is trial file?

    A. Trail file is a text file that pro/e generates, ercording everything the user is doing on pro/engineer,

    and is pro/e crash; one can run the trail file to save his data

    2) o! to interchange the positions of thro!s of a para"etric #$% in detailing?

    A. &ix index

    ') What is the difference in config.pro and config.!in?

    A. config.pro is setting of pro/e lie units. (earch paths. %ap eys etc. config. !in is setting of

    interface

    *) What is +factor and +factor?

    A. - factor and factors are for"ula used to calculate developing length of sheet "etal.

    ) What is for"ulae of developed length?

    A. 0a3045s/2)pi5angle/167 8

    Where a, 8.......... are the straight length, 3 radius, 4 correction factor and s "aterial thicness

    9) What is datu" target?

    A. :atu" targets is used to indicate critical "easure"ent points on the dra!ing

    ) What is.dtl file?

    A. .dtl file controls the 8ehavior of dra!ings.

    6) What are snap lines?

    A. They are helping lines that you create in dra!ing to arrange di"ensions, 8alloons, notes

  • 7/23/2019 Creo interview QA

    2/2

    A. A 3i88on surface is a datu" that represents a tangent field created along a 8ase curve. The 3i88on

    surface is tangent to reference curves that intersect the 8ase curve.

    1) What is the difference 8et!een reroute and redefine?

    A. 3eroute is taing the feature up or do!n in "odel tree and redefine is defining the feature again.

    19) What is si"plified representation and seleton "odel?

    A.

    1) What is restructure?

    A. 3estructure is placing the restructuring the parts in asse"8ly. ou can tae one part fro" an

    asse"8ly and put it in so"e su8 asse"8ly and vice versa

    16) o! to associate a particular independent text !ith a vie!?

    A. roup co""and situated in edit ta8

    1ngineer?

    A. o"inal no tolerance sho!n), plus/"inus, plus/"inus sy""etric, li"its.

    21) What is the difference 8et!een B%oveC and B%ove TextC?

    A. %ove allo!s you to "ove the selected ite" any!here. %ove text allo!s you to "ove the selected

    ite" only parallel to the el8o!.

    22)