Jesters Hat

For this fun project you can use any kind of medium weight cotton fabric, printed, plain. Just mix and match. You will find templates to download at our web site, www.husqvarnaviking.com.

Sewing Supplies· Husqvarna Viking Huskylock· Husqvarna Viking Sewing machine· 3/4 yd (70 cm) of cotton fabric· 4 cones of overlock thread· Sewing thread· 3 bells· 1 large wooden bead· Wadding/Stuffing/Fiberfill

Husqvarna Viking Accessories· Tear Away™ stabilizer

You can find these and many other accessories in the Husqvarna Viking Accessory User’s Guide or on our website www.husqvarnaviking.com, for purchase at your nearest Husqvarna Viking Dealer.

1/4" (6 mm) seam allowance included.

CUTPrint out the templates for pattern pieces and cut out. Put the pattern pieces together with Scotch tape matching the markings in the corners, see illustration. Place them on the fabric and cut out 3 pieces. Piece 5 is the pattern piece for the facing, cut 3 of those as well.

Designed and Created by Tinneke Pot

J esters hat Diag ram

Illu 1

illu 2

illu 3

Jesters hat Diag ram

Illu 1

illu 2

illu 3

K E E P I N G T H E W O R L D S E W I N G

J esters hat Diag ram

Illu 1

illu 2

illu 3

Illustration A.

Illustration B.

VSM Group AB • SE-561 84 Huskvarna, Swedenwww.husqvarnaviking.com

SEWThread your Huskylock and set it for a 4 thread overlock seam. Place the facing at the lower edge right sides together and sew. Press seam allowance to one side. Repeat for all pieces. Place the pieces wrong sides together and sew the edges together from the lower edge to the cut markings as illustrated, the seams will end up on the right side of the hat. Leave the thread ends at the cut marking. Illustration A.

Sew the “points” together in the same way. Leave the thread ends at the top of each point.Illustration B.

Thread your sewing machine with sewing thread on top and in the bobbin. Turn under the facing at the lower edge to the wrong side and sew a seam all around close to the edge of the facing. Illustration C.

Attach the bells on top of each point using the thread ends. Attach the large bead in the center of the hat in the same way.

Put some wadding/stuffing/ fiberfill inside the points to make them stand up.

J esters hat Diag ram

Illu 1

illu 2

illu 3

J esters hat Diag ram

Illu 1

illu 2

illu 3

Illustration C.

Jesters Hat, 4

Jesters hat del 4

a

a

Jesters hat del 5

d

dJesters Hat, 5

Jesters Hat, 3

Jesters hat del 3

a

a

b

b

Jesters Hat, 2

Jesters hat del 2

b

b

c

c

Jester hat del 1

c

c d

d

Jesters Hat, 1