closer process control
TRANSCRIPT
![Page 1: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/1.jpg)
![Page 2: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/2.jpg)
![Page 3: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/3.jpg)
Prepared By : Mazadul Hasan sheshirID: 201000040000813th Batch Wet Processing Technology Email: [email protected] University
Southeast University Department Of Textile Engineering
I/A 251,252 Tejgaon Dhaka Bangladesh
![Page 4: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/4.jpg)
INTRODUCTION:INTRODUCTION:Waste water is very similar in textile
processing, which do harms for environment and regular activities of mankind. Water is used various textile processes, they are mentioned below-
cleaning the raw material,many different industrial processes
(sizing,desizing, scouring, bleaching, mercerizing,dyeing, printing and finishing), andrinsing steps during the whole
production.
![Page 5: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/5.jpg)
![Page 6: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/6.jpg)
What is closer process What is closer process control:control:
Closer process control is a process, which control the pollution load in textile effluent. By this process, the pollution load can be reduced by 30-40percent.
![Page 7: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/7.jpg)
The closer process controlled The closer process controlled by following implements:by following implements:
Reduction in chemical usage.Recovery and re-use of
chemicals.Process modification.Flow or volume reduction.
![Page 8: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/8.jpg)
Reduction in chemical usage:Reduction in chemical usage:
In the finishing operation, the starch is used in large quantities. The unutilized eventually joins the effluent stream. Its amount should be optimized though it is estimated that it will always remain somewhat in excess of what is required. Obviously, this excess should be diverted for different ratio. In summer it should be sun-dried and in winters it should be evaporated thus obtained should be disposed of as solid waste.
![Page 9: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/9.jpg)
In bleaching operations, chlorine and per oxides are used. They should be mixed with dyeing effluent in order to decolorize it.
In kiering mercerizing processes caustic soda is used in large quantities. It should be recycled by readjusting its concentration.
![Page 10: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/10.jpg)
Process modification:Process modification:
Certain change in processes can reduce the amounts and concentrations of waste materials. E.g.change in dyeing method(use of Exhaust dyeing , Standing bath dyeing , Pad-batch dyeing ).
Exhaust dyeing: Exhaust dyeing in which a batch of fibre is dyed from a
liquor that is used only once and then discarded. This technique enables dyers to produce matching colours on different batches of fibre with relative case (provided that the composition of the dye liquor and the dyeing conditions are carefully controlled) but obviously leads to the wastage of chemicals that are not consumed in the dye bath. However, provided that dyes which exhaust well are used, the loss of dyestuff is negligible and other chemicals used in the dye bath are relatively cheap.
![Page 11: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/11.jpg)
Standing bath dyeing:Standing bath dyeing is basically similar to
exhaust dyeing. However, after the first dyeing the dye bath is replenished with dyestuff and chemicals and a further dyeing is carried out. This replenishment may be repeated several times. Experience is required to calculate the exact amount of dyestuff and chemicals needed for replenishment.
Pad-batch dyeing:Pad-batch dyeing is a recently-developed method
based on the use of reactive dyes. It is often carried out in the cold and uses low liquor to fibre ratios (1: 1 compared with 20: 1 for exhaust dyeing).
![Page 12: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/12.jpg)
Recovery and re-use of Recovery and re-use of chemicals:chemicals:Size selectionReplace starch-based sizes with synthetic
sizes. The advantages of this is a reduced pollution load as synthetic sizes have lower BOD levels, and they can be recycled for reuse.
DesizingThe effluent from desizing will contain the
sizes that were added onto the yarn before weaving/knitting. Using and recycling synthetic sizes in place of starch sizes will reduce the pollution load from desizing.
![Page 13: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/13.jpg)
Scouring Detergents should be easily biodegradable.
Avoid the following detergents: linear alkyl benzene sulphonate; dialkyl-dimthyl ammonium chloride with poor biodegradability (e.g. EDTA; phosphonic acid). Reuse scour wash water for desizing. Recycle continuous scour wash water to batch scouring.
Bleaching Replace the use of chlorites and
hypochlorite's with hydrogen peroxide. Ensure that bleaching is carried out efficiently. Recycle bleach wash water for scouring. Use vacuum slots to remove excess solution which can then be reused.
![Page 14: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/14.jpg)
Mercerizing:Recycling of sodium hydroxide through
evaporation for reuse in mercerizing or scouring will decrease the pollution load and chemical consumption.
GeneralUse modern equipment.Replace batch processes with continuous processes. Install counter-current washing.Combine processes such as desizing, bleaching and
scouring. Replace harmful chemicals with those of lower
environmental impact. Reuse wash water for cleaning equipment and
screens.
![Page 15: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/15.jpg)
Flow or volume reduction:Flow or volume reduction:
The waste flow may be reduced by the reuse of process water, counter flow waste, segregation of weak waste for disposer without treatment, changes in process and other similar means.
![Page 16: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/16.jpg)
Conclusions:Conclusions: The textile industry emits a wide variety
of pollutants from all stages in the processing of fibers and fabrics. These include liquid effluent, solid waste, hazardous waste, emissions to air and
noise pollution. It is important to investigate all aspects of reducing wastes from the textile industry, as not only will it result in improved environmental performance, but also substantial savings for the individual companies.
![Page 17: Closer Process Control](https://reader033.vdocuments.us/reader033/viewer/2022052410/554967b0b4c905dd558b4ab4/html5/thumbnails/17.jpg)