close window2
TRANSCRIPT
Close Window
Assessment System
1. Assessment Selection 2. Assessment Settings 3. Take Assessment
Take Assessment - ENetwork Final Exam - CCNA Exploration: Network Fundamentals (Version 4.0)
Time Remaining:
1 Which memory contents will change as a result of using the Router# erase startup-config command on a router?
RAM
ROM
flash
NVRAM
2Which table accurately associates the RFC 1918 private IP addresses with the correct network mask?
3 A network administrator is asked to design a new addressing scheme for a corporate network. There are 60 users in the main office, 40 users in the branch office, 28 users in manufacturing, 12 in the sales office, and 4 users in the research office. Which VLSM addressing scheme that uses the 192.168.88.0/24 network will fulfill the requirements while wasting the fewest addresses?
192.168.88.0/26 main192.168.88.32/26 branch192.168.88.64/26 manufacturing192.168.88.96/27 sales192.168.88.128/28 research192.168.88.0/26 main192.168.88.64/26 branch192.168.88.128/27 manufacturing192.168.88.160/28 sales192.168.88.176/29 research192.168.88.0/27 main192.168.88.32/27 branch192.168.88.64/28 manufacturing192.168.88.80/29 sales192.168.88.88/30 research192.168.88.0/27 main192.168.88.64/28 branch192.168.88.80/28 manufacturing192.168.88.96/29 sales192.168.88.104/30 research
4
Refer to the exhibit. A router, whose table is shown, receives a packet that is destined for 192.168.1.4. How will router treat the packet?
The packet will be dropped.
The packet will be forwarded via FastEthernet 0/0.
The packet will be forwarded to the destination host.
The packet will be forwarded to the 192.168.1.3 next-hop address.
5 Which range of port numbers are reserved for services that are commonly used by applications that run on servers?
0 to 255
0 to 1023
1024 to 49151
49152 to 65535
6Which information is used by the router to determine the path between the source and destination hosts?
the host portion of the IP address
the network portion of the IP address
host default gateway address
the MAC address
7 Which OSI layer offers ordered data reconstruction services?
application layer
network layer
presentation layer
session layer
transport layer
8Which device should be used for enabling a host to communicate with another host on a different network?
switch
hub
router
host
9
Refer to the exhibit. The diagram represents the process of sending e-mail between clients. Which list correctly identifies the component or protocol used at each numbered stage of the diagram?
1.MUA 2.MDA 3.MTA 4.SMTP 5.MTA 6.POP 7.MDA 8.MUA
1.MUA 2.POP 3.MDA 4.SMTP 5.MTA 6.MDA 7.SMTP 8.MUA
1.MUA 2.POP 3.SMTP 4.MDA 5.MTA 6.SMTP 7.POP 8.MUA
1.MUA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MDA 7.POP 8.MUA
10A network administrator subnets the network 192.168.1.0/24 into four subnets. Which option correctly addresses Router1 and host A into the second subnet created?
11
Refer to the exhibit. Host A is unable to reach host B on the remote network. A technician attempted to ping the local gateway and the ping was successful. To verify the host configuration, the technician issued the ipconfig command. What is the likely cause of the problem?
The local NIC is incorrectly configured.
The subnet mask on host A is incorrectly configured.
The IP address on host A is incorrectly configured.
The default gateway on host A is incorrectly configured.
12Which option shows the PDU that contains the Layer 3 source and destination addressing for a packet?
13 Which exhibit shows the interface that is configured by the command, router(config)# interface serial 0/0/1?
14
Refer to the exhibit. The command that is shown was issued on a PC. What does the IP address 192.168.33.2 represent?
IP address of the host
default gateway of the host
IP address of the homepage for the host
primary domain name server for the host
IP address of the website resolver1.mooki.local
15
Refer to the exhibit. A student has wired each end of a CAT 5e cable as shown. What is the result? (Choose two.)
The cable is unusable and must be rewired.
The cable is suitable for use as a rollover cable.
The cable is suitable for use as a Fast Ethernet crossover.
The cable is suitable for use as a Gigabit Ethernet straight-through.
The cable is suitable for use between two 100 Mbps Auto-MDIX capable switches.
Showing 1 of 4 <Prev Page: Next>
Close Window
All contents copyright 1992-2009 Cisco Systems, Inc. Privacy Statement and Trademarks.