Do not use any shap objects to clean nozzles

Clean filter washer periodicallly

MAKU SATINJET SLIDE RAIL SHOWERINSTALLATION GUIDETECHNICAL SPECIFICATIONS

Operating Pressure:Min 35 kPa, Max 500 kPa. Recommended installation of a pressure limiting valve if supply exceeds 500kPa.Operating Temperature:Max 70°C.NB: New Zealand Building Code Clause G12 - Water Supplies specifies all outlets used primarily for personal hygiene shall deliver water at a safe temperature.Inlet Connections: All ½" BSP.

Issue A436932

Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet. For your warranty please refer to www.methven.com or call Customer Service

New Zealand0800 804 222

Australia1300 638 483

UK 0800 195 1602

To clean the chrome-plated surface use a soft cloth, soap and warm water. Never use cleaning agents that contain a corrosive acid or a scouring additive.

CLEANING

Water contains lime which remains on the surface after the water has evaporated. These lime deposits can be prevented from forming by wiping immediately after use.

NOTES:

1) Low and unequal systems:Removal of the flow restrictor with pliers may be necessary to optimise flow performance in low or unequal pressure systems only. Flow restrictor is lodged firmly in the end of the handset.

NOTE: TO LOOSEN SLIDERS GRIP ON RAIL ROTATE SIDE PIECE ANTI-CLOCKWISE. ROTATE CLOCKWISE TO TIGHTEN

Orientate rail so that pre-fitted endcap is at bottom of rail

Fitted endcap

1.

5.

3.

7.

2.

6.

4.

8.

Secure the wall boss housings in desired position with 4 screws. Check the mounts are vertical. Ensure the grub screws are located as shown.

NOTE: ENSURE PROTECTION PADS ARE USED BETWEEN WALL BOSSES AND TILES

Fit end cap to top of rail. Ensure drainage hole is at back

Non-Swivelling Cone

Filter Washer

Flat Washer

Swivelling Cone

Match the mountings up to the wall bosses and push into place. Slide the rail up and down if required to centralise the rail on the brackets

Once satisfied that the rail is centralised remove the rail and tighten the tensioning screws until they lock.

Relocate the rail onto wall bosses and tighten grub screws top and bottom.

Fit the internal mounting brackets by locating in slot and rotating 90° as shown.

Once located tighten the screws finger-tight.

grub screw underside

grub screw topside

Wall Boss Housing

Grub Srew

RailHose

Slider

Maku Handset

ElbowScrew

Internal Mounting Bracket

Floor

510-645mm

1850mm

(recomm

ended)