civil and structural capability - amazon s3 trimble autodesk 3d modelling using advance steel and...
TRANSCRIPT
Point of Contact:
Stephen Morfitt, Principal Civil and Structural Engineer Telephone: +44 (0) 1469 576 411 Email: [email protected]
Professionalism ▪ Integrity ▪ Trust ▪ Team Spirit
Our aim is to be our Clients’ Partner of Choice
Engineering &
Design
www.engie-fabricom.co.uk
We have a highly skilled and experienced team of civil and structural engineers, led by a Chartered Engineer. The team is able to provide a wide range of capabilities across a variety of UK industry sectors including Petrochemical, Onshore and Offshore Oil and Gas, and Power in both Brownfield and Greenfield scenarios delivering the following services:
● Structural design: superstructure and foundations
● Third party verification and checking of engineering design
● Lifting and rigging schemes to facilitate the installation, removal and maintenance of equipment
● Structural inspections and assessments
● Strengthening of existing structures and foundations
● Ground investigation
● Site surveys including topographical and laser scanning
● Steelwork fabrication detailing, including connection design calculations
● CDM 2015 “Principal Designer”
● Civil design: roads, paving and drainage
● Vehicle tracking: swept path analysis
● Reinforced concrete detailing
● Site supervision
● Construction management
We pride ourselves on safety and are aware of our duties under the Construction Design and Management (CDM) 2015 regulations and can act as Principal Designer for construction projects. By also acting as Principal Contractor we are able provide the management framework to deliver all onsite project requirements, fast tracked by a seamless integration with the design team.
Civil and Structural Capability
Point of Contact:
Stephen Morfitt, Principal Civil and Structural Engineer Telephone: +44 (0) 1469 576 411 Email: [email protected]
Professionalism ▪ Integrity ▪ Trust ▪ Team Spirit
Our aim is to be our Clients’ Partner of Choice
Engineering &
Design
www.engie-fabricom.co.uk
Using experienced engineers and construction managers to develop and execute discrete packages of work with approved sub-contractors, we are able to design out risk for the whole project life cycle, from construction and operation through to the decommissioning stage. Our civil and structural team use industry standard software packages including:
● StaadPro
● Trimble
● AutoDesk
● 3D Modelling using Advance Steel and Revit
Civil and Structural Capability