city of tukwila plumbing
TRANSCRIPT
\\dcdstore\DCD Common$\Permit Center (Rachelle)\Permit Center Handouts\PDF Form Versions Handouts Page 1 of 1 Revised: June 2019
PLUMBING –
Commercial Structures
City of Tukwila Department of Community Development 6300 Southcenter Boulevard, Suite #100
Tukwila, Washington 98188 Phone: 206-431-3670
Web site: http://www.TukwilaWA.gov
DOCUMENTS
Complete Plumbing-Gas Permit Application
Plan Review Fee – contact Permit Center for fee estimate 206-431-3670.
Washington State Department of Labor and Industries valid contractor’s license required at time of permit
issuance.
Current City of Tukwila business license required at time of permit issuance.
PLANS – 2 sets of working drawings *Minimum sheet size 11” x 17”, maximum sheet size 24” x 36”.
Cover sheet
1. North arrow and scale
2. Building floor plan and show location where the plumbing installation shall occur. Clearly mark or
name the rooms.
3. Address or parcel number
4. If multiple structures are on site, identify the structure that the plumbing work will be located in.
Working drawings
* Plans to be reviewed must be legible, drawn to scale and shall be of sufficient clarity to indicate the
location, nature, and extent of the work proposed. The person or firm responsible for the plumbing
plans shall be indicated on the plans.
* Floor plans shall be two-line drawings. Single line floor plan drawings shall not be accepted.
* The plans must clearly show the plumbing installation of alterations in “floor plan” view with pipe
sizes, piping run distances, and types of fixtures.
* Plumbing “isometric” riser diagram (s) indicating fixtures, drains, traps & vents required.
* If applicable, provide manufactures specifications with sizing for grease interceptors, grease traps, and
indicate trap primers for floor drains etc., and include installation details.
* Where plumbing work includes roof drains and conductors, provide calculations to justify the number
and size of roof drains and conductors.
* Specify material to be used (preferably on the plans or in separate spec. document).
* Each plan sheet by engineer or architect shall be stamped with signature, engineer’s include date of
signature.
* As applicable, Gas piping shall include calculations for pipe sizes, length of pipes, sized for
appliances served. Provide a complete diagram of all piping.