chapter 8 circuit theorems and conversions. objectives apply the superposition theorem to circuit...
Post on 20-Dec-2015
288 views
TRANSCRIPT
Chapter 8
Circuit Theorems and Conversions
Objectives
Apply the superposition theorem to circuit analysis
Apply Thevenin’s theorem to simplify a circuit for analysis
Apply Norton’s theorem to simplify a circuit
Apply the maximum power transfer theorem
Voltage Source
The voltage source ideally provides constant voltage to a load even when the load resistance varies.
In reality, no voltage source is ideal. Voltage sources have some inherent
internal resistance (represented by RS)
When a load is applied to the source, not all of the voltage appears across RL, since some of the voltage is dropped across RS
If RS is very small compared to RL The source approaches ideal
because almost all of the source voltage, VS, appears across the larger resistance, RL
Current Source
The ideal constant current source has an infinitely large internal parallel resistance.
Transistors act basically as current sources (the equivalent model of a transistor does contain a current source).
In a practical current source, some of the current, IS, is through RS, and part is through RL.
If RS >> RL, the current source approaches ideal.
Converting a Voltage Source to a Current Source
The voltage source can be converted to an equivalent current source by:
IS = VS/RS
Converting a Current Source to a Voltage Source
The current source can be converted to an equivalent voltage source by:
VS = ISRS
Find Vs
Superposition Theorem
Some circuits require more than one voltage or current source.
The superposition theorem is a way to determine currents and voltages in a circuit that has multiple sources by considering one source at a time.
General Statement of Superposition Theorem The current in any given branch of a multiple-source circuit
can be found by determining the currents in that particular branch produced by each source acting alone, with all other sources replaced by their internal resistances. The total current in the branch is the algebraic sum of the individual source currents in that branch.
Example
Find the Current Through R2
Find the Current Through R3
Thevenin’s Theorem
Thevenin’s theorem provides a method for simplifying a circuit to a standard equivalent form.
The Thevenin equivalent voltage (VTH) is the open circuit (no-load) voltage between two terminals in a circuit.
The Thevenin equivalent resistance (RTH) is the total resistance appearing between two terminals in a given circuit with all sources replaced by their internal resistances.
Thevenin Equivalent of a Circuit
Find VTH and RTH across A & B
Norton’s Theorem
Norton’s theorem provides a method for simplifying a circuit to a standard equivalent form.
The Norton equivalent current (IN) is the current between two terminals in a circuit.
The Norton equivalent resistance (RN) is the total resistance appearing between two terminals in a given circuit with all sources replaced by their internal resistances.
Summary of Norton’s Theorem
4 Connect IN and RN in parallel to produce the complete Norton equivalent for the original circuit (as shown to the right).
Find the Norton equivalent
Maximum Power Transfer
When a source is connected to a load, maximum power is delivered to the load when the load resistance is equal to the internal source resistance.
The source resistance, RS, of a circuit is the equivalent resistance as viewed from the output terminals using Thevenin’s theorem.
A typical application of the maximum power transfer theorem is in audio systems, where the speaker resistance must be matched to the audio power amplifier in order to obtain maximum output.
Show the load power curve (PRL)
Assume: RL = ½ RSRL = RSRL =2 RS
Summary